Replaces
Part Details
Complete Repair in One Purchase - Stop searching for parts individually and complete your repair with a customized kit or set from DIY Solutions.
High-Quality Parts from Trusted Brands - DIY Solutions' kits and sets are selected from the best automotive brands and include hard-to-find and even obsolete parts you may need for your vehicle.
Guaranteed Fit - DIY Solutions ensures its selected parts are quality-tested to guarantee fit and function.
Assemblies may include halogen or incandescent test bulbs that should be replaced before installation.
Features and Benefits
Item Condition:
New
Attention California Customers:
WARNING: This product can expose you to chemicals including Chromium (Hexavalent Compounds), which is known to the State of California to cause cancer, and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov
Lifetime Warranty
This item is backed by our limited lifetime warranty. In the event that this item should fail due to manufacturing defects during intended use, we will replace the part free of charge. This warranty covers the cost of the part only.
FREE Shipping is standard on orders shipped to the lower 48 States (Contiguous United States). Standard shipping charges apply to Hawaii and Alaska.
Shipping is not available to a P.O. Box, APO/FPO/DPO addresses, US Territories, or Canada for this item.
Expedited is available on checkout to the United States, excluding Alaska, Hawaii.
Final shipping costs are available at checkout.
Created on:
Tools used
Hi, I'm Mike from 1A Auto. We've been selling auto parts for over 30 years. We're dedicated to delivering quality auto parts, expert customer service, fast and free shipping, all backed by our 100% satisfaction guarantee. Visit us at 1AAuto.com, your trusted source for quality auto parts.
So we're going to peel this splash shield back. It also will make it easier if you turn your wheel to the inside of whatever side you're working on so you can open this up. You can it’s in with some 7mm self-tapping screws and some push clips.
I'll start with the 7mm self-tapping screws. Using a flat-bladed screwdriver or trim clip tool, you're going to work these barbed clips out. Now we fold this up. Now you can peel you fender liner back and reach in and disconnect your fog lamp.
These three tabs or clips are tabbed on them on either side. You can squish them together with your fingers and push them out. Two top ones, now you reach out with your other hand to hold the fog light from the front. Squeeze the bottom one, sort of push them out, and then you're going to push from the middle to remove your fog light lens.
To install it, I'm going to leave these clips on here. Feed it in from the front, get it lined up with the holes, push it in, and that will click into place.
Reconnect the harness and your fog light lens is replaced. Pull that down. And then pull this down and push it back into place.
Replace the barbed clips if you took them out. Reinstall the 7mm self-tapping screws.
Thanks for watching. Visit us at 1AAuto.com for quality auto parts, fast and free shipping, and the best customer service in the industry.
Tools used
Tools used
Tools used
