Replaces

Chevrolet GMC Cadillac Steering Kit 3 Piece Set TRQ PSA58488

Description
Vehicle Fit
Warranty & Shipping
How-To & Tools
Q&A

Part Details

  • Quantity:   3 Piece Set
  • Kit Includes:
      (1) Pitman Arm
      (1) Idler Arm Bracket
      (1) Idler Arm

Specifications:

  • Comes as a 3 Piece Kit
    • Fits LH (Driver Side) & RH (Passenger Side)
  • Direct replacement
  • Built to strict quality control standards

Our steering and suspension components come pre-greased, sealed for long life, and do not require the extra maintenance typically required by greasable versions.

Direct Fit

Application-specific, with no modifications required.

Rigorously Tested

Made from higher quality materials than the competition. Built to have a longer life in any environment or road conditions.

State of the Art Manufacturing

By the same factories that the OEMs use.

Prepackaged for Your Convenience

Carefully assembled to include all of the parts you need, saving time and money.

Item Condition: New

Attention California Customers:

WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov.

Lifetime Warranty

This item is backed by our limited lifetime warranty. In the event this item should fail due to manufacturing defects during intended use, we will replace the part free of charge.

Note: When replacing steering components, it is recommended to have a professional alignment performed on the vehicle afterwards. This will ensure proper tracking and even tire wear.

  1. step : Remove the wheel (1:00)
    • Loosen the lug nuts.
    • Raise and secure the vehicle
    • Remove the lug nuts and the wheel.
  2. step : Remove the front shield (1:15)
    • Use a 15 mm socket and ratchet.
    • Remove the four bolts.
  3. step : Remove the Idler Arm (1:25)
    • Remove the 24 mm bolt securing the idler arm to the steering linkage
    • Use a joint fork and a hammer to separate the joint.
    • Remove the three other bolts securing the idler arm.
    • Use a Tie Rod Puller to pull apart the idler arm and the idler shaft.
  4. step : Install the new idler arm (4:34)
    • Assemble your new idler arm to your idler shaft, threading on the bushing and nut.
    • Bolt in the idler arm assembly into place, tightening up the three nuts.
    • Bolt in the end of the idler arm assembly to the steering gear.
    • Torque the nuts and bolts to 80 ft lbs.
    • Install the cotter pin.
    • Use a grease gun and fill the grease fitting.
  5. step : Reassembly (7:25)
    • Replace the shield with the four 15mm bolts.
    • Clip the air bag harness back in.
    • Put the wheel back on and lower the car
    • Using a star pattern torque the lug nuts to 120-140 ft lbs

Tools needed for replacement:

    General Tools

  • Hammer
  • Jack Stands
  • Large C-Clamp

  • Ratchets & Related

  • 1/2 Inch Breaker Bar
  • Ratchet
  • Socket Extensions
  • Torque Wrench

  • Sockets - Metric

  • 15mm Socket
  • 18mm Socket
  • 19mm Socket
  • 22mm Socket
  • 24mm Socket

  • Specialty Tools

  • Grease Gun
  • Tie Rod Fork
  • Tie Rod Puller

  • Wrenches - Metric

  • 18mm Wrench

Customer Q&A
Ask a question to 1A Auto customers who purchased the product
Does the parts for part number 1ASFK02087 fit single cab or extended cab 1994 Chevy c1500 p/u?
Dana S May 30, 2016
These will fit all model 94 Chevy c1500. It is not specific to the cab size.
Derek C May 31, 2016
I would think these would fit either size bed since they are front end parts. I have a 97 K2500 HD and ordered a similar set from 1A and they fit perfect.. The folks at 1A will exchange them if they dont fit.
Elizabeth R May 31, 2016
They will fit both, but setting the toe will be necessary. The "line up splines" (the four large ones ) are a bit off. I installed it properly with my steering wheel locked at 12 oclock. When done however, I had to hold the wheel at 2 oclock to go straight.
Robert H May 31, 2016
My truck is a 1999 Tahoe 4 wheel drive. Not sure if it is compatible with a 1994. However, The idler fit fine, but the pitman arm only went on halfway. Could not use it. Sorry I was not of any help to you.
Greg V June 1, 2016
Yes it should, we used it on our k1500 suburban 4x4. No problems installing - still trucking with our 1A Auto part.
Alice S June 1, 2016
I have a 1995 single cab K1500 that this part fits. I dont know if the 2 w.d. versions have different systems.
Mike H June 1, 2016
Whats the difference in the steering components from a 1993 Chevrolet k1500 to a 1990 chevy k1500?
Jeff S July 29, 2019
Thank you for your inquiry! While we could not tell you specifically what is different between those models, we can tell you that these parts specifically will be different.
Tim K July 30, 2019

Fits the following Makes:

Year Make Model Description
1999-2000Cadillac Escalade Cadillac Escalade Steering Kit 3 Piece Set
1993-1994Chevrolet Blazer Full Size Chevrolet Blazer Full Size Steering Kit 3 Piece Set
1993-1999Chevrolet C1500 Truck Chevrolet C1500 Truck Steering Kit 3 Piece Set
1993-2000Chevrolet C2500 Truck Chevrolet C2500 Truck Steering Kit 3 Piece Set
1993-2000Chevrolet C3500 Truck Chevrolet C3500 Truck with Independent Front Suspension Steering Kit 3 Piece Set
1993-1999Chevrolet K1500 Truck Chevrolet K1500 Truck Steering Kit 3 Piece Set
1993-2000Chevrolet K2500 Truck Chevrolet K2500 Truck Steering Kit 3 Piece Set
1993-2000Chevrolet K3500 Truck Chevrolet K3500 Truck Steering Kit 3 Piece Set
1993-1999Chevrolet Suburban C1500 Chevrolet Suburban C1500 Steering Kit 3 Piece Set
1993-1999Chevrolet Suburban K1500 Chevrolet Suburban K1500 Steering Kit 3 Piece Set
1993-1999Chevrolet Suburban K2500 Chevrolet Suburban K2500 Steering Kit 3 Piece Set
1995-1999Chevrolet Tahoe Chevrolet Tahoe Steering Kit 3 Piece Set
2000Chevrolet Tahoe Chevrolet Tahoe V8 5.7L Steering Kit 3 Piece Set
1993-1999GMC C1500 Truck GMC C1500 Truck Steering Kit 3 Piece Set
1993-2000GMC C2500 Truck GMC C2500 Truck Steering Kit 3 Piece Set
1993-2000GMC C3500 Truck GMC C3500 Truck with Independent Front Suspension Steering Kit 3 Piece Set
1993-1999GMC K1500 Truck GMC K1500 Truck Steering Kit 3 Piece Set
1993-2000GMC K2500 Truck GMC K2500 Truck Steering Kit 3 Piece Set
1993-2000GMC K3500 Truck GMC K3500 Truck Steering Kit 3 Piece Set
1993-1999GMC Suburban C1500 GMC Suburban C1500 Steering Kit 3 Piece Set
1993-1999GMC Suburban C2500 GMC Suburban C2500 Steering Kit 3 Piece Set
1993-1999GMC Suburban K1500 GMC Suburban K1500 Steering Kit 3 Piece Set
1993-1999GMC Suburban K2500 GMC Suburban K2500 Steering Kit 3 Piece Set
1993-1999GMC Yukon GMC Yukon Steering Kit 3 Piece Set
2000GMC Yukon GMC Yukon V8 5.7L Steering Kit 3 Piece Set

Part Interchange

Brand Label Part Number
DIY Solutions SUS05314
DIY Solutions SUS06354
DIY Solutions SUS05333
MOOG K6722
MOOG K6447
MOOG K6335
MOOG Chassis Products K6335
MOOG Chassis Products K6722
MOOG Chassis Products K6447

This item may be interchangeable with parts from other brands with the above part numbers. This information is provided only for reference and does not guarantee that the item you are purchasing is identical to parts with part numbers from the brands listed above. To confirm that this item fits your vehicle, use the above "Check Vehicle Fit" option.

Part 1ASFK02087
In Stock


Orders must be placed by 2pm ET
Delivery options for:

Estimated Arrival Cost


Deliveries made to PO Boxes and FPO may take longer. See our Shipping & Delivery for more information.

TRQ
Brand #: PSA58488