Chevy GMC Cadillac Front Passenger Side Power Window Regulator with Motor ACDelco 25885879 - ACWRG00004

AC Delco Window Regulator with Motor: 25885879

This window regulator is a OE GM replacement part! The very same part you would receive if purchased from your local dealer!

Specifications:

• Brand New AC Delco Window Regulator
• Fits RH (Passenger Side) FRONT
• Dual rail style
• Replaces dealer part numbers: 20914718, 19120847, 20914718, 20945139, 25885879
• Includes power window motor

Item Condition: New

Lifetime Warranty

This item is backed by our limited lifetime warranty. In the event this item should fail due to manufacturing defects during intended use, we will replace the part free of charge.

step : Removing the Door Panel (0:51)

• Pry off the trim piece inside the door pull with a flat blade screwdriver
• Pry off the trim piece inside the door handle with a flat blade screwdriver
• Remove the two 10mm bolts inside the door pull
• Remove the 10mm bolt inside the door handle
• Pry out the upper panels by hand
• Remove the upper door handles
• Pry out the door panel by hand
• Lift the door panel up and off
• Disconnect the window switch wiring harness
• Disconnect the latch cables from the door handle
• Carefully peel off the water shield

step : Removing the Window Regulator (3:28)

• Remove the three 10mm bolts from the metal bracket
• Loosen the two 10mm bolts that hold the window to the regulator
• Raise the window by hand
• Hold the window in place with painter's tape
• Remove the four 10mm bolts from the regulator
• Remove the 10mm bolts from the window motor
• Disconnect the window motor lead
• Pull the window regulator out through the door

step : Reinstalling the Regulator (5:24)

• Insert the bolts into the window regulator
• Push the regulator into the door
• Hang the regulator by its bolts
• Insert the two 10mm bolts into the regulator
• Insert the 10mm bolt into the window motor
• Connect the window motor lead
• Connect the switch panel
• Raise the regulator into the window
• Disconnect the switch panel
• Remove the painter's tape from the window
• Insert the two 10mm bolts that hold the window to the regulator
• Insert the three 10mm bolts to the metal bracket

step : Reinstalling the Door Panel (7:01)

• Carefully replace the water shield
• Connect the latch cables to the door handle
• Connect the window switch wiring harness
• Lift the door panel into place
• Push in the door panel clips
• Lift the upper panels into place
• Push in the door panel clips
• Insert the 10mm bolt inside the door handle
• Insert the two 10mm bolts inside the door pull
• Push in the trim piece inside the door handle
• Push on the trim piece inside the door pull