Replaces
Frequently bought together
Assemblies may include halogen or incandescent test bulbs that should be replaced before installation.
Features and Benefits
Item Condition:
New
Attention California Customers:
WARNING: This product can expose you to chemicals including Chromium (Hexavalent Compounds), which is known to the State of California to cause cancer, and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov
This item is backed by our limited lifetime warranty. In the event this item should fail due to manufacturing defects during intended use, we will replace the part free of charge. This warranty covers the cost of the part only.
The bulbs are for testing and not covered under our warranty. Our warranty applies to the light assembly only.
FREE Shipping is standard on Orders shipped to the lower 48 States (Contiguous United States). Standard shipping charges apply to Hawaii, Alaska and US Territories. Shipping is not available to Canada.
Expedited is available on checkout to the United States, excluding Alaska, Hawaii and US Territories as well as P.O. Boxes and APO/FPO/DPO addresses. Final shipping costs are available at checkout.
Created on:
Tools used
Brought to you by 1AAuto.com, your source for quality replacement parts and the best service on the Internet.
In this video, we're going to show you tail light replacement on this 2001 Chevy Impala, same as a '97 to '03, and no tools are necessary.
To replace the tail light, pretty easy, you're going to see a loosen type of. Then, you pull this back, and then there's three wing nuts, and you can also use, I believe, a 10-mm wrench. Remove those three.
Tail light pulls back. If you're looking to replace a bulb, you want to disconnect your connection here, which basically from the bottom, there's a little tab and pull. Here's a little tab, and you pull that connector. There's your tail light off. Your bulbs are back in here. Pull up on these little tabs. You can see there's water in this one. Pull that plate off. Then, the bulbs just pull right out. Then once you have this plate off, the bulbs pull out and push back in. The plate just pops right back on like that.
New tail light from 1A Auto. Everything is going to go in just the same. Pops right in. Just kind of make sure you use the plug in the right spot. Pop that on. Then, make sure all your studs go in and then use your nuts on the back side.
Then, you just put this back in place and you're all set.
We hope this helps you out. Brought to you by www.1AAuto.com, your source for quality replacement parts and the best service on the Internet. Please feel free to call us toll free 888-844-3393. We're the company that's here for you on the Internet and in person.
