Chevy Blazer S10 Pickup Chrome & Dark Argent Mesh Grille - 1ABGR00056

This replacement grille is just what you need to get your vehicle in good looking form again!

Specifications:

• Chrome plated injection molded one piece plastic
• Dark argent painted with chrome center strip
• Mesh style
• Can be painted by buyer to any colored desired or installed as is
• High quality item that is built to strict quality control standards
• Replaces dealer part number: 15048519
• Direct bolt on
• Has proper area for the Chevy emblem (not included)
• Designed for Base and LS models but will fit all S10 models

Makes a great replacement and has substantial cost savings over a dealer unit.

48 States Only:

Due to shipping restrictions, we can only ship this to a physical address within the Contiguous U.S. (lower 48 states).

NOTE: It is necessary to reuse your original hardware, as new hardware is not included with this item.

Item Condition: New

Lifetime Warranty

This item is backed by our limited lifetime warranty. In the event this item should fail due to manufacturing defects during intended use, we will replace the part free of charge.

step : Remove the head light (0:50)

• Pull the two tabs up from the top of the assembly.
• Take the headlight assembly and pull it out
• Disconnect the wiring harness.

step : Remove the parking light (1:19)

• Unclips the parking light
• Disconnect the bulb and set it aside.

step : Remove the grille (1:52)

• Unclip the grille, prying the tabs now exposed with your flat blade screwdriver.
• Repeat the process on the other side of the vehicle.
• If you are replacing the grille, transfer the tab style clips to the new grille from the old one.

step : Install the grille (2:57)

• Thread the harnesses through the parking light and head light gaps.
• Clip the grille onto the front of the vehicle.

step : install the lights (4:19)

• Connect the parking light assembly up.
• Clip it into place.
• Connect the headlight assembly.
• Insert the tabs, taking care not to pinch the wiring.
• Once the assembly is in place, clip the two locking tabs in.