Part Details

  • Light Option: Halogen

Specifications

  • Fits RH (Passenger Side)
  • Includes lens and housing
  • Bulbs not included
  • Correct for Halogen Style Headlights
    • not correct for HID (High Intensity Discharge) or Xenon Style Headlights
Direct Fit Replacement

Direct fit replacement for OEM assembly

Trouble-free Installation

Uses same wiring as original assembly.  No cutting or splicing required.

DOT and SAE Compliant

Meets federal regulations for on-road use

Item Condition: New

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser.

Bulb Note:

Unless otherwise noted, our lights do not include bulbs, though occasionally lighting manufacturers do include bulbs in the lights. If you happen to receive a lighting product (Headlight, Tail light, parking light, fog light etc.) that comes with the bulbs, the bulbs are not covered under our warranty. Our warranty applies only to the light assembly..

  1. step : Removing the Bumper (0:33)
    • Untwist the pins along the radiator shield and pull them out
    • Remove the shields by pulling up
    • Pull the weatherstripping up
    • Pry the push clips out from atop the bumper with a trim tool
    • Remove the 10mm bolt from the bracket
    • From behind the bumper, pry out the trim clips from the rubber shield on side of the grille
    • Pry out the push clips from beneath the bumper with a trim tool
    • Disconnect the fog light wiring harness
    • Pull the air duct on each side down and out
    • Loosen the hose clamp on the headlight washer hose with needle nose pliers
    • Pry off the hose with a right angle pick
    • Insert a bolt to the end of the hose to block fluid
    • Pry out the push clips in the wheel well
    • Pry back the wheel well liner
    • Remove the 10mm bolt on each side from behind the wheel well liner
    • Pull the bumper back and off the vehicle
  2. step : Removing the Headlight Housing (7:55)
    • Remove the two 10mm nuts from the headlight
    • Pull the headlight straight-forward
    • Disconnect the electrical connector
  3. step : Installing the Headlight Housing (9:22)
    • Connect the electrical connector
    • Press the headlight into place
    • Tighten the 10mm nuts to the headlight
  4. step : Installing the Bumper (10:46)
    • Press the bumper into place
    • Tighten the 10mm bolts to the bracket behind the grille
    • Tighten the 10mm bolts to the grille behind the wheel well
    • Insert the wheel well into place
    • Press the push clips to the wheel well
    • Connect the fog light connector
    • Remove the bolt from the headlight washer hose
    • Connect the hose to the washer pump
    • Tighten the hose clamp with needle nose pliers
    • Reinstall the shield to the side of the grille
    • Press on the push clips beneath the bumper
    • Attach the air duct to each side
    • Press the push clips atop the bumper into place
    • Press on the weatherstripping
    • Clip in the protective shields
    • Press on the push clips to the top of the shields

Tools needed for replacement:

    General Tools

  • Pick

  • Pliers, Cutters & misc Wrenches

  • Needle nose pliers

  • Ratchets & Related

  • Socket Extensions
  • Ratchet

  • Screwdrivers & Related

  • Flat Blade Screwdriver

  • Sockets - Metric

  • 7mm Socket
  • 10mm Socket

  • Specialty Tools

  • Trim Tool Set

5.0 / 5.0
4 Reviews
5 Stars
4 Stars
3 Stars
2 Stars
1 Star
4
0
0
0
0
Excellent replacement better than OEM part
This replacement headlight looks just like the original OEM part. The adjustment screw isn’t as high of build quality as the original headlight assembly but otherwise the light looks the same. I was surprised to find out that the headlight came with the bulbs already installed! An added bonus of this headlight is a small drain pipe in the bottom of the headlight — something the OEM part does not have! I replaced the OEM part because the headlight was filling up with water and it actually corroded one of the contacts in the terminal because there was nowhere for the water to drain but where the wires ended. This replacement is worth the money and I’m happy I didn’t get a used one from the junk yard for $270.
October 8, 2018
Purchased
4 weeks ago
replacement light
The light fit perfectly and works awesome . it was pretty easy to install , considering it is a Cadillac!
July 11, 2017
Purchased
1 year ago
Bought the wrong one... But the product is still great
Standard headlight, meant to buy one to match my other one. But it's all good, this one does the job.
June 27, 2017
Purchased
1 year ago
excellent all the around, fast order placement very satisfied
March 2, 2017
Purchased
1 year ago
Start typing your question and we'll check if it was already asked and answered. Learn More
No questions have been asked about this item. Be the first!

Vehicle Fit

Year Make Model Description
2008-2013Cadillac CTS Cadillac CTS Halogen Headlight Passenger Side
2014Cadillac CTS Cadillac CTS Coupe Halogen Headlight Passenger Side
2014Cadillac CTS Cadillac CTS Wagon Halogen Headlight Passenger Side

This part replaces:

  • Partslink GM2503309
  • Hollander 114-01122R
  • TYC 20-6961-00-1
  • DEPO 332-11B5R-AF7
  • OE # 25897358
Part #: 1ALHL01885


Order must be placed by 4pm ET

Get it in: 2 - 4 Business Days

Want it sooner? Choose Next Day Air at Checkout

How-to Video:

(16:39 min)