This new direct fit, aftermarket, stainless steel catalytic converter is a great replacement. It is made of the highest grade materials for long lasting durability.

Specifications:

  • Fits RH (Passenger Side)
  • High quality stainless steel
  • Includes all flanges for direct installation
  • EPA Certified
  • Built to strict quality control standards

 

 

5 Year Warranty

This item is backed by a 5 Year Warranty. In the event this item should fail during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser. 

Emissions Note:

Due to state emissions regulations, we cannot ship this item to the state of California as it is not C.A.R.B ( California Air Research Board) approved for use in this state.

Due to New York state emissions regulations, this item cannot be installed on a California emissions equipped vehicle in the state of New York.

All emissions information for a vehicle can be found on a tag under the hood. If the tag is missing, you can contact a dealership with your VIN to determine which emissions system your vehicle is equipped with.

  1. step : Removing the Catalytic Converter (0:47)
    • Raise and support the vehicle
    • Remove the four 14mm bolts from the exhaust flanges
    • Allow the exhaust to hang
    • Loosen the O2 sensor with an O2 sensor socket and ratchet
    • Twist off the O2 sensor by hand
    • Remove the 10mm bolt from the heat shield
    • Pull back the heat shield
    • Remove the two 13mm bolts from the exhaust manifold
    • Pull the catalytic converter down and out
  2. step : Installing the Catalytic Converter (2:18)
    • Put the 13mm bolts into place on the exhaust manifold
    • Lift the catalytic converter into place
    • Start the 13mm nuts by hand
    • Tighten the 13mm nuts and bolts
    • Put the heat shield into place
    • Insert the 10mm bolt for the heat shield
    • Start the O2 sensor by hand
    • Tighten the O2 sensor with an O2 sensor socket
    • Lift the exhaust into place
    • Insert the 14mm bolts into the exhaust flanges
    • Tighten the 14mm bolts to 16 foot-pounds of torque

Tools needed for replacement:

    Ratchets & Related

  • Ratchet
  • Torque Wrench
  • Socket Extensions

  • Sockets - Metric

  • 7mm Socket
  • 10mm Socket
  • 13mm Socket
  • 14mm Socket

  • Specialty Tools

  • O2 Sensor Socket

  • Wrenches - Metric

  • 22mm Wrench
  • 13mm Wrench

There are no reviews for this item. Write Review
Start typing your question and we'll check if it was already asked and answered. Learn More
No questions have been asked about this item. Be the first!

Vehicle Fit

  • 2004-2007 Cadillac CTS Catalytic Converter V6 3.6L Passenger Side
  • 2005-2007 Cadillac CTS Catalytic Converter V6 2.8L Passenger Side

This part replaces:

  • OE # 12622974
Part #: 1ACCD00315

Out of Stock

How-to Video:

(04:19 min)