Specifications:

  • Comes as a matched Pair
  • Includes both LH (Driver) & RH (Passenger) Side Front
  • Cross drilled, Slotted, And Zinc Coated
  • Direct replacement
  • 10 1/2 Inch Diameter

Note:
The rotors do not include wheel bearings or seals. You will need to reuse your originals.

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser. Please keep your invoice for proof of this warranty.

Wear and Tear

This item is backed by a warranty against defects in materials and workmanship under its intended use. The warranty does not cover normal wear and tear. Please keep your invoice for proof of this warranty.

  1. step : Reassemble the bearings. (0:30)
    • Use race installation tools or a block of wood to assemble the inner bearing.
    • Pack the outer bearing with bearing grease.
    • Inspect the spindle and clean it with a paper towel.
    • Mount the rotors and insert the outer bearing.
    • thread your washer and bolt on.
    • Tighten the bolt some with your ratchet and then loosen it; this will seat the outer bearing.
    • Put the nut and dust cap on.
  2. step : Install the new brakes (5:09)
    • Clean the brake rotors with brake cleaner.
    • Clean the caliper sleeves with a wire brush.
    • Apply anti-seize grease to the edges of the brake pads where they slide into the calipers.
    • Compress your caliper pistons with a large C-Clamp
    • Put the brake pads into the caliper.
    • Mount the caliper.
    • Clean up your caliper bolts and apply a little anti-seize grease to them.
    • Torque the caliper bolts to 45 ft lbs.
  3. step : Put the wheel back on (8:53)
    • Thread the lug nuts on
    • Lower the vehicle
    • Torque the lug nuts in a star pattern to 100 ft lbs

Tools needed for replacement:

    Allen Wrenches

  • 3/8 Inch Allen Wrench

  • General Tools

  • Jack Stands
  • Hammer
  • Wire Brush
  • Floor Jack
  • Large C-Clamp

  • Materials, Fluids, and Supplies

  • Paper Towels
  • Block of Wood
  • Anti-Seize Grease
  • Brake Parts Cleaner
  • Bearing Grease

  • Pliers, Cutters & misc Wrenches

  • Slip-Joint Pliers

  • Ratchets & Related

  • Torque Wrench

  • Sockets - Metric

  • 19mm Socket
  • 27mm socket

  • Specialty Tools

  • Race Installation Tools

5.0 / 5.0
1 Review
5 Stars
4 Stars
3 Stars
2 Stars
1 Stars
1
0
0
0
0
Not much use yet, but so far, so good. When paired with the Akebono brake pads, it's a smooth combination with no break in period whatsoever. Will send another review after they have more miles on them.
February 24, 2017
Purchased
1 year ago
Start typing your question and we'll check if it was already asked and answered. Learn More
No questions have been asked about this item. Be the first!

How-to Video:

(09:53 min)

Tools List:

    Allen Wrenches

  • 3/8 Inch Allen Wrench

  • General Tools

  • Jack Stands
  • Hammer
  • Wire Brush
  • Floor Jack
  • Large C-Clamp

  • Materials, Fluids, and Supplies

  • Paper Towels
  • Block of Wood
  • Anti-Seize Grease
  • Brake Parts Cleaner
  • Bearing Grease

  • Pliers, Cutters & misc Wrenches

  • Slip-Joint Pliers

  • Ratchets & Related

  • Torque Wrench

  • Sockets - Metric

  • 19mm Socket
  • 27mm socket

  • Specialty Tools

  • Race Installation Tools



This part replaces:

  • Nakamoto 5547-DSZ

Vehicle Fit

  • 1982-1987 Buick Regal Front Cross Drilled & Slotted Zinc Coated Brake Rotor Pair Performance Nakamoto
  • 1983-1990 Chevy Blazer S10 2 Wheel Drive Front Cross Drilled & Slotted Zinc Coated Brake Rotor Pair Performance Nakamoto
  • 1991 Chevy Blazer S10 2 Wheel Drive Front Cross Drilled & Slotted Zinc Coated Brake Rotor Pair without ABS Brakes Performance Nakamoto
  • 1982-1987 Chevy Camaro Front Cross Drilled & Slotted Zinc Coated Brake Rotor Pair Performance Nakamoto
  • 1988-1992 Chevy Camaro Front Cross Drilled & Slotted Zinc Coated Brake Rotor Pair 10.5" (267mm) Diameter Rotors Performance Nakamoto
  • 1982-1987 Chevy El Camino Front Cross Drilled & Slotted Zinc Coated Brake Rotor Pair Performance Nakamoto
  • 1982-1983 Chevy Malibu Front Cross Drilled & Slotted Zinc Coated Brake Rotor Pair Performance Nakamoto
  • 1982-1988 Chevy Monte Carlo Front Cross Drilled & Slotted Zinc Coated Brake Rotor Pair Performance Nakamoto
  • 1982-1993 Chevy S10 Pickup 2 Wheel Drive Front Cross Drilled & Slotted Zinc Coated Brake Rotor Pair Performance Nakamoto
  • 1994-1995 Chevy S10 Pickup 2 Wheel Drive Front Cross Drilled & Slotted Zinc Coated Brake Rotor Pair L4 2.2L Performance Nakamoto
  • 1982-1987 GMC Caballero Front Cross Drilled & Slotted Zinc Coated Brake Rotor Pair Performance Nakamoto
  • 1983-1990 GMC Jimmy S-15 2 Wheel Drive Front Cross Drilled & Slotted Zinc Coated Brake Rotor Pair Performance Nakamoto
  • 1991 GMC Jimmy S-15 2 Wheel Drive Front Cross Drilled & Slotted Zinc Coated Brake Rotor Pair without ABS Brakes Performance Nakamoto
  • 1982-1990 GMC S-15 Pickup 2 Wheel Drive Front Cross Drilled & Slotted Zinc Coated Brake Rotor Pair Performance Nakamoto
  • 1991-1993 GMC S-15 Sonoma 2 Wheel Drive Front Cross Drilled & Slotted Zinc Coated Brake Rotor Pair Performance Nakamoto
  • 1994-1995 GMC S-15 Sonoma 2 Wheel Drive Front Cross Drilled & Slotted Zinc Coated Brake Rotor Pair L4 2.2L Performance Nakamoto
  • 1982-1987 Olds Cutlass Front Cross Drilled & Slotted Zinc Coated Brake Rotor Pair Performance Nakamoto
  • 1982-1988 Olds Cutlass Supreme RWD Front Cross Drilled & Slotted Zinc Coated Brake Rotor Pair Performance Nakamoto
  • 1982-1986 Pontiac Bonneville Front Cross Drilled & Slotted Zinc Coated Brake Rotor Pair Performance Nakamoto
  • 1982-1987 Pontiac Firebird Front Cross Drilled & Slotted Zinc Coated Brake Rotor Pair Performance Nakamoto
  • 1988-1992 Pontiac Firebird Front Cross Drilled & Slotted Zinc Coated Brake Rotor Pair 10.5" (267mm) Diameter Rotors Performance Nakamoto
  • 1982-1987 Pontiac Grand Prix Front Cross Drilled & Slotted Zinc Coated Brake Rotor Pair Performance Nakamoto
Part #: 1APBR00248

Ships Same Day for orders placed by 4 P.M. ET

Nakamoto
Brand #: 5547-DSZ

We're here to help

1A Auto Parts

Customer Feedback

"Thanks for the fast reliable service. Great price, and the headlights were as good as oem or better!!! Keep up the good work..."
- Dwuan M.
Read More