Brake Pads Nakamoto CD785 - 1ABPS00080

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser. Please keep your invoice for proof of this warranty.

Wear and Tear

This item is backed by a warranty against defects in materials and workmanship under its intended use. The warranty does not cover normal wear and tear. Please keep your invoice for proof of this warranty.

step : Removing the Wheel (0:48)

• Loosen the lug nut covers with a 22mm socket
• Pry off the center cap with a flat blade screwdriver
• Loosen the lug nuts with the vehicle on the ground
• Raise the vehicle with a floor jack
• Secure the vehicle on jack stands
• Remove the lug nuts
• Pull off the wheel

step : Removing the Brake Pads (1:20)

• Remove the 18mm bolts from the brake caliper
• Pry the brake pads into the caliper with a flat blade screwdriver to push in the pistons
• Pull the caliper aside
• Pry the brake pads off with a flat blade screwdriver
• Remove the brake pad slides

step : Removing the Brake Rotor (2:54)

• Spray the 21mm bolts with penetrating oil if rusted
• Remove the 21mm bolts from the brake caliper bracket
• Pull off the brake caliper bracket
• Pull the rotor off
• If the rotor will not come off, thread the lug nuts and strike the hub area of the rotor with the ball end of a ball peen hammer

step : Preparing the New Brake Pads and Rotors (5:05)

• Clean the rotor with brake parts cleaner
• Clean the brake pad slides with a wire brush
• Apply grease to the caliper slides
• Apply grease to the brake pad tabs
• Clip the brake pad slides to the caliper bracket
• Put an old pad in the caliper
• Use a large C-clamp and the old pad to push the pistons back

step : Installing the New Brake Rotor (6:55)

• Slide the rotor on
• Thread on one lug nut to hold the rotor in place
• Put the bracket back into place
• Start the bolts by hand
• Tighten the bolts to 100 foot-pounds of torque

step : Installing the New Brake Pads (7:48)

• Install the new brake pads into the bracket
• Put the caliper on
• Thread the bolts by hand
• Tighten the bolts to 100 foot-pounds

step : Reattaching the Wheel (9:25)

• Slide the wheel into place
• Start the lug nuts by hand
• Tighten the lug nuts preliminarily
• Lower the vehicle to the ground
• Tighten the lug nuts to 100 foot-pounds in a crossing or star pattern
• Reattach the center cap
• Tighten the lug nut covers with a 22mm socket

step : Testing the Brakes (9:53)

• Pump your brakes repeatedly until they feel firm
• Test your brakes at 5 miles per hour and then 10 miles per hour
• Road test the vehicle