Brake Kit Nakamoto CD905, CD888, 31341-DSZ, 31387-DSZ - 1APBS00324

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser. Please keep your invoice for proof of this warranty.

Wear and Tear

This item is backed by a warranty against defects in materials and workmanship under its intended use. The warranty does not cover normal wear and tear. Please keep your invoice for proof of this warranty.

step : Remove the wheel (0:52)

• Loosen your lug nuts with a 19 mm socket and breaker bar
• Raise and secure the vehicle.
• Remove the lug nuts the rest of the way and set the wheel aside.

step : Inspect and remove the brakes (1:07)

• Observe the thickness of your brake pads.
• Inspect your rotors for excessive wear or deep gouges.
• Loosen the caliper bolt with a 14 mm socket and ratchet.
• Use a flat blade screwdriver to compress the caliper pistons some and remove the caliper.
• Unbolt the 19 mm caliper bracket bolts.
• Remove the rotor and pop the plug out of the rotor.

step : Install the new disc brakes (2:07)

• Hit the emergency brake with brake cleaner.
• Clean your new rotor with brake cleaner (mineral spirits would work just as well)
• Install the brake rotor onto the vehicle and replace the little access plug.
• Mount the caliper bracket and torque the 19 mm bolts to 85-90 ft lbs
• Use a C-clamp to compress the caliper.
• Install the brake pads, dabbing a bit of anti-seize grease on the edges to get it in.
• Push the caliper into place and bolt it down with your 14 mm socket.
• Torque the 14 mm bolt to 25 ft lbs.

step : Mount the wheel (4:39)

• Put the wheel on the vehicle.
• Hand-tighten the lug nuts.
• Lower the vehicle.
• Torque your lug nuts in a star pattern to 100 ft lbs.