Warranty & Shipping
How-To & Tools
Product Reviews
Vehicle Fit

Part Details

  • Quantity:   Pair
  • Front or Rear Location:   Rear

These brake drums are just what you need to get your vehicle stopping in good order again!


  • Comes as a PAIR
    • Fits both LH (Driver Side) & RH (Passenger Side) REAR
  • Replaces dealer part numbers: 15650087, 15693466, 15016408, 177393
  • Direct replacements
  • Fits 6 stud wheels
  • Size: 11-5/32 x 2-3/4"

These brake drums make great replacements and have excellent value over the price of dealer brake drums.

Item Condition: New

WARNING: Cancer and Reproductive Harm -

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser.

Wear and Tear

This item is backed by a warranty against defects in materials and workmanship under its intended use. The warranty does not cover normal wear and tear. Please keep your invoice for proof of this warranty.

  1. step : Removing The Wheel and Tire (1:19)
    • Loosen the lug nuts
    • Raise and Secure the vehicle
    • Remove the lug nuts
    • Remove the wheel and tire
  2. step : Applying Penetrating Oil (1:39)
    • Douse each wheel stud with penetrating oil
    • Let sit
    • Rotate the brake 180 degrees
    • Douse each wheel stud with penetrating oil again
    • Let sit
  3. step : Removing the Brake Drum (1:57)
    • Make sure to wear safety glasses
    • Use the hammer to loosen up the brake drum
    • Remove the brake drum
  4. step : Removing the Brake Hardware (2:24)
    • Remove the springs using the vice grip or the brake spring tool
    • Remove the spring for the adjuster lever
    • Remove the pins by pushing an turning them with the vice grip
    • Remove theseperator bar to pull the shoes free
    • Put hardware aside if reusing it
  5. step : Removing the Brake Shoes (5:20)
    • Use the small screwdriver to drive the clip off the attaching pin
    • Remove the brake shoes
  6. step : Seperating the Emergency Brake Lever and the Adjuster (6:16)
    • Push the shoes together by hand
    • Pull off the adjuster and spring
    • Pry the emergency brake lever off with the screwdriver
  7. step : Cleaning the Backing Plate (6:47)
    • Clean the backing plate with a wire brush
  8. step : Inspecting the Adjuster (7:18)
    • Make sure the adjuster turns freely
    • Make sure all parts of the adjuster turn independently
    • If using a new adjuster, lubricate the threads
  9. step : Connecting the Brake Shoes (7:56)
    • Identify the rear shoe by inspecting the lining
    • Attach the adjuster and spring
    • Connect the front shoe to the adjuster and spring
  10. step : Installing the Brake Shoes (8:48)
    • Apply grease to slots on back side of shoes
    • Apply grease to the backing plate
    • Put the shoes in place
    • Thread pins through from the back, starting with the front shoe
    • Attatch the springs with the vice grips
    • Put the emergency brake lever behind the rear shoe
    • Attach the spring washer and locking clip
    • Replace the separator bar and lever
    • Attach the hardware for the rear shoe
    • Reattach the springs using the vice grips
  11. step : Installing the Drum (15:16)
    • Slide the drum into place
    • Test the fit
    • Run out the adjuster
    • Try the drum again
    • Continue to adjust until the drum drags somewhat
  12. step : Adjusting the Brakes (16:05)
    • Remove the rubber plug behind the backing plate
    • Tighten the brakes with a brake spoon
    • Test the fit
    • Back off the adjustment if necessary
    • Apply penetrating oil
    • Replace the rubber plug
  13. step : Replacing the Wheel (17:16)
    • Slide the wheel back on
    • Replace the lug nuts
    • Start Tightening the lug nuts
    • Let the vehicle down to the ground
    • Torque the lug nuts to 110 foot-pounds
  14. step : Testing the brakes (17:29)
    • Test stopping at low speeds
    • Back up and apply your brakes several times
    • Road test the vehicle

Tools needed for replacement:

    General Tools

  • Large Hammer
  • Floor Jack
  • Wire Brush
  • Jack Stands

  • Materials, Fluids, and Supplies

  • Rust Penetrant
  • White Grease

  • Pliers, Cutters & misc Wrenches

  • Vise Grip Pliers
  • Lug Wrench

  • Ratchets & Related

  • 1/2 Inch Breaker Bar

  • Screwdrivers & Related

  • Flat Blade Screwdriver

  • Sockets - Metric

  • 22mm Socket

  • Specialty Tools

  • Brake Spoon
  • Brake Spring Tool

There are no reviews for this item.
Will this fit my car? Add a vehicle to make sure
Customer Q&A
Ask a question to 1A Auto customers who purchased the product
No questions have been asked about this item.
Year Make Model Description
1999-2000Cadillac Escalade Cadillac Escalade Brake Drum Rear Pair
1992-1999Chevy Suburban K1500 Chevy Suburban K1500 Rear Brake Drum Pair for Models with 6 Lug Wheels
1995-2000Chevy Tahoe Chevy Tahoe 4 Wheel Drive Brake Drum Rear Pair
1992-1999GMC Suburban K1500 GMC Suburban K1500 Brake Drum Rear Pair for Models with 6 Lug Wheels
1995-2000GMC Yukon GMC Yukon 4 Wheel Drive Brake Drum Rear Pair
Part #: 1ABDS00076

Order must be placed by 4pm ET

Get it in: 2 - 4 Business Days

Want it sooner? Choose Next Day Air at Checkout

How-to Video:

(18:01 min)