Replaces

Brake Caliper Pair Raybestos Opti-Cal FRC11331N, FRC11332N - RABCS00006

Specifications:

  • Brand New Brake Caliper
  • Comes as a Pair
  • Includes LH (Driver Side) & RH (Passenger Side) Rear
  • OE-matched design and specifications
  • Engineered to meet or exceed OE performance and durability
  • All new casting and parts NO CORE required

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser. Please keep your invoice for proof of this warranty.

  1. step : Remove wheel. (1:15)
    • Remove hub cap or center cap if you have it.
    • While your car is still on the ground, use your 19mm socket to loosen your lug nuts.
    • Jack up and secure your car with jack stands.
    • Remove the lug nuts with your 19mm socket and ratchet.
    • Remove the wheel and set aside.
  2. step : Remove the rear brake calipers (1:46)
    • Use a screwdriver to force the pistons back in.
    • Remove the two 14mm bolts to remove the calipers.
    • Use a wire tie to fasten the caliper out of the way.
    • Use your screwdriver to pry out your brake pads.
    • Remove the two 18mm bolts on the caliper bracket to remove it.
    • Remove the caliper bolt sleeves.
    • Check their condition and clean them with a wire brush if necessary.
    • Pull off the brake rotor.
    • Screw in the two 10M bolts to remove the rotor.
    • Take care not to damage the lug studs.
  3. step : Install new rear brake rotor and pads (6:30)
    • Clean new rotor with brake cleaner.
    • Insert your new pads into the brackets.
    • Put your caliper bracket back on, and tighten the bolts to 90-100 ft lbs.
    • Compress the caliper piston with a c-clamp to reset the pistons.
    • Mount the caliper on the bracket and torque the bolts in to 15-20 ft lbs.
  4. step : Put the rear wheel back on (10:25)
    • Make sure to use a star pattern when putting your wheel lugs back on.
    • Tighten to 100 ft lbs.
    • Replace hubcap/center cap.
  5. step : Test and set brakes (11:00)
    • Before driving the car again, start it up and pump the brakes a few times to get the pistons in the brakes in place.
    • Test the brakes in your driveway before taking the car onto the road.
    • Set your rotors by evenly braking from 30mph to 10mph, 50mph-30mph and finally 70mph to 40mph.
    • This is best done on a straight back road without any traffic.

Tools needed for replacement:

    General Tools

  • Floor Jack
  • Jack Stands
  • Large C-Clamp
  • Large Hammer
  • Rubber Mallet

  • Materials, Fluids, and Supplies

  • Anti-Seize Grease
  • M10 x 7cm bolts
  • Wire Ties

  • Pliers, Cutters & misc Wrenches

  • Lug Wrench

  • Ratchets & Related

  • 1/2 Inch Breaker Bar
  • Ratchet
  • Torque Wrench

  • Sockets - Metric

  • 14mm Socket
  • 18mm Socket
  • 19mm Socket

There are no reviews for this item. Write Review
Start typing your question and we'll check if it was already asked and answered. Learn More
No questions have been asked about this item. Be the first!

Vehicle Fit

  • 2004-2007 Buick Rainier Brake Caliper Pair Rear Raybestos Opti-Cal FRC11331N, FRC11332N
  • 2003-2006 Chevy SSR Brake Caliper Pair Rear Raybestos Opti-Cal FRC11331N, FRC11332N
  • 2002-2009 Chevy Trailblazer Brake Caliper Pair Rear Raybestos Opti-Cal FRC11331N, FRC11332N
  • 2002-2006 Chevy Trailblazer EXT Brake Caliper Pair Rear Raybestos Opti-Cal FRC11331N, FRC11332N
  • 2002-2009 GMC Envoy Brake Caliper Pair Rear Raybestos Opti-Cal FRC11331N, FRC11332N
  • 2002-2006 GMC Envoy XL Brake Caliper Pair Rear Raybestos Opti-Cal FRC11331N, FRC11332N
  • 2004-2005 GMC Envoy XUV Brake Caliper Pair Rear Raybestos Opti-Cal FRC11331N, FRC11332N
  • 2003-2008 Isuzu Ascender Brake Caliper Pair Rear Raybestos Opti-Cal FRC11331N, FRC11332N
  • 2002-2004 Olds Bravada Brake Caliper Pair Rear Raybestos Opti-Cal FRC11331N, FRC11332N
  • 2005-2009 Saab 9-7X Brake Caliper Pair Rear Raybestos Opti-Cal FRC11331N, FRC11332N

This part replaces:

  • Raybestos Opti-Cal FRC11331N, FRC11332N
Part #: RABCS00006

Out of Stock

Raybestos Opti-Cal
Brand #: FRC11331N, FRC11332N

How-to Video:

(11:30 min)