Audi Power Window Switch - 1AWES00255

Specifications:

• Fits LH (Driver Side) or RH (Passenger Side) Front or Rear
• Direct replacement
• Built to strict quality control standards

Our electrical and electronic parts are subject to strict quality control testing. Please ensure proper diagnosis of this item before purchasing as the item cannot be returned once installed or plugged in.

Item Condition: New

Attention California Customers:

WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov.

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser.

step : Removing the Door Panel (0:47)

• Disconnect the negative battery terminal
• Pry off the silver panel with a flat blade screwdriver
• Remove the four Phillips screws from the door panel
• Remove the Phillips screw underneath the panel
• Pry off the trim cap underneath the arm rest
• Remove the Phillips screw underneath the arm rest
• Pry out the door panel with a door panel clip tool or putty knife and towel
• Lift the door panel up and off
• Unlatch the door handle cable
• Disconnect the window motor wiring harness
• Disconnect the speaker wiring harness

step : Fixing the Door Panel Clips (2:18)

• Skip this step unless your bottom screw did not come out or the door panel clips fell out
• For the screw, hold its clip with a pair of pliers
• Remove the screw with a Phillips screwdriver
• Reinstall the clip into the door with a hammer if necessary
• Apply glue to any lost clips and insert them back into the door

step : Removing the Power Window Switch (2:33)

• Disconnect the power window switch wiring harness
• Remove the nine T20 Torx screws from the arm rest
• Carefully pry the switch out with a flat blade screwdriver

step : Installing the Power Window Switch (3:16)

• Insert the switch into the arm rest
• Insert the arm rest into the door panel
• Tighten the nine T20 Torx screws to the arm rest
• Connect the power window switch wiring harness

step : Reinstalling the Door Panel (3:40)

• Connect the speaker wiring harness
• Connect the window motor wiring harness
• Latch the door handle cable
• Lift the door panel into place
• Push in the door panel clips
• Insert the Phillips screw underneath the arm rest
• Insert the Phillips screw underneath the panel