Airbag Clock Spring Dorman 525-032 - DMSTC00007

Warranty & Shipping
How-To & Tools
Product Reviews
Vehicle Fit


  • Dorman Brand New Clock Spring Assembly 
  • Direct replacement
  • Built to strict quality control standards

Our electrical and electronic parts are subject to strict quality control testing. Please ensure proper diagnosis of this item before purchasing as the item cannot be returned once installed or plugged in.

Item Condition: New

Attention California Customers:

WARNING:  This product can expose you to chemicals including Lead and Lead Compounds, which are known to the State of California to cause cancer, and birth defects or other reproductive harm.  For more information, go to

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser.

  1. step : Disconnecting the Battery (0:43)
    • Disconnect the negative terminal on the battery with a 10mm wrench
  2. step : Removing the Air Bag (1:08)
    • Wait for one minute after disconnecting the battery
    • Insert a pick into the slot on the side of the column
    • Press the spring retainer with the pick and pull the air bag slightly out
    • Repeat for the other side
    • Disconnect the air bag connectors
    • Set the air bag down on a bench face up and away from electrical equipment
  3. step : Removing the Steering Wheel (3:59)
    • Hold the steering wheel by hand
    • Loosen the nut with a 13/16 inch socket
    • Shake the wheel back and forth gently to loosen
    • Lift the steering wheel slightly off
    • Disconnect the electrical connector
    • Remove the steering wheel
  4. step : Removing the Lower Dash Panel (5:55)
    • Pull the fuse panel cover off
    • Remove the Phillips screws from the lower dash panel
    • Remove the 10mm bolt from the parking release cable
    • Slide the parking cable and latch back and off the lower dash
    • Pull the lower dash panel straight out
  5. step : Removing the Steering Column Cover (7:08)
    • Pull the steering adjust lever off the steering cover
    • Unclip the lower steering column cover from the upper steering column cover
    • Pull off the lower steering column cover
    • Lower the steering wheel
    • Pull off the upper steering column cover
  6. step : Removing the Airbag Clock Spring (8:04)
    • Remove the snap ring with snap ring pliers
    • Secure the clock spring with a piece of painter's tape
    • Snip the wire-tire with wire cutters
    • Remove the clock spring
    • Disconnect the wiring harness
    • Trace the clock spring wire and disconnect the connector
    • Release the wire from the clips
    • Remove the clock spring and wire
  7. step : Installing the Airbag Clock Spring (11:55)
    • Insert the airbag clock spring into place
    • Place the snap ring on with snap ring pliers
    • Connect the wiring harness
    • Run the clock spring wire into place, using wire-ties if needed
    • Connect the clock spring wiring harness
  8. step : Installing the Steering Column Cover (15:15)
    • Line up the upper steering column cover with the shifter boot
    • Clip the upper cover into place
    • Raise the steering wheel
    • Clip the lower cover onto the upper cover
    • Push the steering wheel adjuster into the steering column
  9. step : Installing the Lower Dash Trim (16:21)
    • Line the lower dash trim into place
    • Line the parking brake lever into place
    • Tighten the 10mm bolt to the parking brake lever
    • Tighten the Phillips head screw to the lower dash panel
    • Clip the fuse panel cover on
  10. step : Installing the Steering Wheel (17:37)
    • Feed the air bag wires through the upper slot of the steering wheel
    • Connect the electrical connector
    • Tighten the steering wheel nut with a 13/16 inch socket
    • Torque the nut to 30 foot-pounds
  11. step : Installing the Air Bag (19:26)
    • Connect the air bag electrical connectors
    • Press the air bag into place
  12. step : Connecting the Battery (20:04)
    • Connect the negative terminal with a 10mm socket

Tools needed for replacement:

    General Tools

  • Pick

  • Materials, Fluids, and Supplies

  • Painter's Tape

  • Pliers, Cutters & misc Wrenches

  • Snap Ring Pliers
  • Wire Cutters

  • Ratchets & Related

  • Socket Extensions
  • Torque Wrench
  • Ratchet

  • Screwdrivers & Related

  • Flat Blade Screwdriver
  • Phillips Head Screwdriver

  • Sockets - Metric

  • 10mm Socket

  • Sockets - SAE

  • 13/16 Inch Socket

  • Specialty Tools

  • Trim Tool Set

  • Wrenches - Metric

  • 10mm Wrench

There are no reviews for this item.
Will this fit my car? Add a vehicle to make sure
Customer Q&A
Ask a question to 1A Auto customers who purchased the product
No questions have been asked about this item.
Year Make Model Description
2007-2012Chevy Silverado 1500 Chevy Silverado 1500 4 Speed Automatic Transmission Airbag Clock Spring Dorman 525-032
2007-2010Chevy Suburban 1500 Chevy Suburban 1500 4 Speed Automatic Transmission Airbag Clock Spring Dorman 525-032
2007-2012Chevy Tahoe Chevy Tahoe 4 Speed Automatic Transmission Airbag Clock Spring Dorman 525-032
2007GMC Sierra 1500 GMC Sierra 1500 New Body Style 4 Speed Automatic Transmission Airbag Clock Spring Dorman 525-032
2008-2012GMC Sierra 1500 GMC Sierra 1500 4 Speed Automatic Transmission Airbag Clock Spring Dorman 525-032
2007-2012GMC Yukon GMC Yukon 4 Speed Automatic Transmission Airbag Clock Spring Dorman 525-032
2007-2008GMC Yukon XL 1500 GMC Yukon XL 1500 4 Speed Automatic Transmission Airbag Clock Spring Dorman 525-032
Only 1 left in stock
Part #: DMSTC00007

Order must be placed by 4pm ET
Delivery options for:

Estimated Arrival Cost

Deliveries made to PO Boxes and FPO may take longer. See our Shipping & Delivery for more information.

Get it in: 2 - 4 Business Days

Want it sooner? Choose Next Day Air at Checkout

Brand #: 525-032

How-to Video:

(21:34 min)