Replaces

Acura EL Honda Civic A/C Condenser Cooling Fan Assembly - 1AACF00023

Our aftermarket cooling fan assemblies are some of the highest quality replacements on the market! This AC Condenser cooling fan assembly is a complete, ready to bolt on, direct replacement part.

Specifications:

  • New, not rebuilt, electric motor(s)
  • Geometrically designed plastic blade(s) for optimal circulation and uniform balance
  • Shroud designed to ensure structural integrity and endurance for maximum performance
  • 100% Performance factory tested
  • Replaces original assemblies that are melted or worn out
  • Comes with proper plug(s) for trouble free installation
  • Built to strict quality control standards
  • Direct bolt on

Now you can buy a high quality AC Condenser cooling fan motor assembly that is built to strict quality control standards. This cooling motor assembly makes a great replacement and has substantial cost savings over a dealer fan assembly.

WARNING:  This product can expose you to chemicals including Chromium (Hexavalent Compounds), which is known to the State of California to cause cancer, and birth defects or other reproductive harm.  For more information, go to www.P65Warnings.ca.gov.

Returns Note:

Our electrical and electronic parts are subject to strict quality control testing.  Once the item has been installed or plugged in, it is no longer eligible for a refund.  The item may be eligible for replacement, only if it is found to have a manufacturing defect. Before purchasing, please ensure proper diagnosis of the failed original part is performed.

Item Condition: New

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser.

    Before starting this repair, make sure that your engine is cool

  1. step : Removing the Bumper Cover (0:47)
    • Pry up the four clips atop the bumper with a flat blade screwdriver
    • Remove the 10mm bolt at the front of the wheel well on both sides
    • Pull the inner fender down and away from the bumper on both sides
    • Pry down the retaining clips underneath the bumper
    • Pull each side of the bumper cover out and pull the cover forward and off
  2. step : Draining the Coolant (1:36)
    • Make sure the engine is cool
    • Place a drain pan beneath the coolant drain plug
    • Twist the coolant drain plug
    • Let the coolant drain
    • Remove the radiator cap
  3. step : Removing the Battery (2:19)
    • Loosen the negative battery cable with a 10mm wrench
    • Loosen the positive batter cable with a 10mm wrench
    • Pull the clip from the mounting bolt
    • Remove the mounting bolts with a 10mm wrench
    • Remove the battery mount
    • Remove the battery cover
    • Lift the battery up and out
    • Remove the lower battery retainer
  4. step : Removing the Coolant Overflow Bottle (3:08)
    • Remove the 10mm bolt from the coolant overflow bottle
    • Lift the reservoir up and out, unclipping the hose as you go
    • Pry off the retaining clip from the lower hose
    • Twist and pull the hose off
  5. step : Removing the Radiator Cooling Fan (3:44)
    • Place a drip pan underneath the coolant hose
    • Remove the 10mm bolt from the ground wire
    • Loosen the coolant hose clamp with pliers
    • Remove the coolant hose
    • Remove the two 10mm bolts from the radiator fan assembly
    • Disconnect the coolant temperature sensor
    • Pull the radiator fan assembly up and out
    • Disconnect the fan assembly wiring harness
  6. step : Removing the A/C Cooling Fan (5:50)
    • Disconnect the fan wiring harness
    • Remove the two 10mm bolts mounting the top of the fan in place
    • Remove the two 10mm bolts holding the condenser
    • Remove the two 10mm bolts from the A/C bracket
    • Remove the four A/C brackets
    • Squeeze the teeth on the fan's hose clip and push it through the bracket
    • Pull the cooling fan up
    • Disconnect the fan wiring harness
    • Remove the cooling fan
  7. step : Installing the A/C Cooling Fan (7:26)
    • Insert the cooling fan into place
    • Connect the cooling fan wiring harness
    • Re-clip the fan's hose
    • Tighten the 10mm mounting nuts to the top of the fan
    • Tighten the two 10mm bolts to the A/C bracket
    • Tighten the two 10mm bolts to the condenser
  8. step : Installing the Radiator Cooling Fan (9:33)
    • Insert the cooling fan down into place
    • Connect the fan wiring harness
    • Tighten the 10mm mounting bolts to the top of the fan
    • Reconnect the coolant temperature sensor
    • Insert the coolant hose into place
    • Tighten the coolant hose clamps
    • Tighten the 10mm ground bolt
  9. step : Reinstalling the Coolant Overflow Bottle (11:34)
    • Insert the hose into place
    • Tighten the hose clamp to the hose with a pair of pliers
    • Clip the hose to the bottle
    • Insert the coolant bottle into its slot
    • Tighten the 10mm bolt to the bottle
  10. step : Installing the Battery (12:31)
    • Insert the lower battery retainer
    • Insert the battery into place
    • Replace the battery cover
    • Insert the battery mount into place
    • Reinstall the 10mm bolts
    • Connect the positive battery cable with a 10mm wrench
    • Connect the negative battery cable with a 10mm wrench
    • Replace the clip to the mounting bolt
  11. step : Installing the Bumper Cover (13:11)
    • Insert the bumper cover into place, the top underneath the latch lever
    • Tighten the retaining clips atop the bumper
    • Reinstall the 10mm bolt at the front of the wheel well on both sides
    • Push the inner fender into place
    • Tighten the retaining clips underneath the bumper
  12. step : Refilling the Coolant (14:10)
    • Tighten the drain plug
    • Insert a funnel into the radiator opening
    • If you are reusing coolant, filter the coolant with a t-shirt
    • Replace the radiator cap

Tools needed for replacement:

    Materials, Fluids, and Supplies

  • Rust Penetrant
  • Cloth Rags

  • Pliers, Cutters & misc Wrenches

  • Channel-Lock Pliers
  • Needle nose pliers

  • Ratchets & Related

  • Ratchet
  • Socket Extensions

  • Screwdrivers & Related

  • Phillips Head Screwdriver
  • Flat Blade Screwdriver

  • Wrenches - Metric

  • 10mm Wrench

5.0 / 5.0
1 Review
5 Stars
4 Stars
3 Stars
2 Stars
1 Star
1
0
0
0
0
Exactly what I needed
Right part at the right price. Perfect fit. Will definitely be doing business with 1A Auto again
January 24, 2017
Purchased
1 year ago
Start typing your question and we'll check if it was already asked and answered. Learn More
No questions have been asked about this item. Be the first!

Vehicle Fit

Year Make Model Description
2001Acura EL Acura EL (excluding Japan Built Models) A/C Condenser Cooling Fan Assembly
2001Honda Civic Honda Civic (excluding Japan Built Models) A/C Condenser Cooling Fan Assembly
2002Honda Civic Honda Civic 4 Door Sedan A/C Condenser Cooling Fan Assembly
2002-2005Honda Civic Honda Civic 2 Door Coupe A/C Condenser Cooling Fan Assembly
2003-2005Honda Civic Honda Civic (excluding Hybrid Models) 4 Door Sedan A/C Condenser Cooling Fan Assembly

This part replaces:

  • Partslink HO3113114
  • Hollander 674-59603
  • Dorman 620-220
  • TYC 610380
  • DEPO 317-55027-200
  • OE # 38616PMMA01
Part #: 1AACF00023


Order must be placed by 4pm ET

Get it in: 2 - 4 Business Days

Want it sooner? Choose Next Day Air at Checkout

How-to Video:

(15:51 min)