Our direct fit gas-charged shock absorbers help to restore your vehicle’s handling and ride quality to just like new.

In the past, replacing struts required specialized tools to compress, remove and transfer the old spring and mount.  Pre-assembled with all new parts, our complete strut and spring assemblies make this job much quicker and easier for the do-it-yourself mechanic.

Each complete strut & spring assembly contains:

  • Upper Strut Mount
  • Strut Bearing
  • Coil Spring
  • Boot & Bumper Kit
  • Gas-charged Strut 
Pre-Assembled

Pre-assembled, loaded strut & spring assemblies allow for a quicker, safer install than replacing with just bare struts.  No spring compressor required! 

Trouble-Free Install

Trouble-free install includes the matched parts needed to get the job done. New mounts, bearings, springs and hardware will provide a better ride for your vehicle and save you time from not having to do the job again because a used part failed afterwards.

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser. Please keep your invoice for proof of this warranty.

  1. step : Removing the Shock (0:50)
    • Apply rust penetrant to the shock bolts
    • Hold the lower shock bolt with a 21mm wrench
    • Remove the lower 21mm nut from the shock
    • Remove the upper 21mm bolt from the shock
    • Tap the lower 21mm bolt out with a hammer
    • Remove the upper 21mm bolt by hand
    • Pull the shock down and out
  2. step : Installing the Shock (2:24)
    • Put the shock into place
    • Start the upper 21mm bolt into the shock
    • Raise the shock mounting point with a jack
    • Push the shock into the lower mounting point
    • Start the lower 21mm bolt and nut onto the shock
    • Tighten the two 21mm bolts to 80 -85 foot-pounds.
    • Repeat Steps 1 and 2 for the other shock

Tools needed for replacement:

    General Tools

  • Hammer
  • Jack Stands
  • Floor Jack

  • Materials, Fluids, and Supplies

  • Rust Penetrant

  • Ratchets & Related

  • Torque Wrench
  • A Piece of Pipe (for leverage)
  • Ratchet

  • Screwdrivers & Related

  • Flat Blade Screwdriver

  • Sockets - Metric

  • 21mm Socket

  • Wrenches - Metric

  • 21mm wrench

There are no reviews for this item. Write Review
Start typing your question and we'll check if it was already asked and answered. Learn More
No questions have been asked about this item. Be the first!

Vehicle Fit

  • 2014-2015 Chevy Silverado 1500 4 Wheel Drive Front & Rear Shock & Strut Kit 4 Piece Set
  • 2014-2015 GMC Sierra 1500 4 Wheel Drive Front & Rear Shock & Strut Kit 4 Piece Set

This part replaces:

  • Monroe 239112
  • Monroe 911533
  • KYB 345074
Part #: 1ASSP01690

Out of Stock

How-to Video:

(04:39 min)