Replaces
This part doesn’t fit a . Select from parts that fit.
Light Assembly Lifetime Warranty
Frequently bought together
Assemblies may include halogen or incandescent test bulbs that should be replaced before installation.
Features and Benefits
Item Condition:
New
Attention California Customers:
WARNING: This product can expose you to chemicals including Chromium (Hexavalent Compounds), which is known to the State of California to cause cancer, and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov
This item is backed by our limited lifetime warranty. In the event this item should fail due to manufacturing defects during intended use, we will replace the part free of charge. This warranty covers the cost of the part only.
The bulbs are for testing and not covered under our warranty. Our warranty applies to the light assembly only.
FREE Shipping is standard on Orders shipped to the lower 48 States (Contiguous United States). Standard shipping charges apply to Hawaii, Alaska and US Territories. Shipping is not available to Canada.
Expedited is available on checkout to the United States, excluding Alaska, Hawaii and US Territories as well as P.O. Boxes and APO/FPO/DPO addresses. Final shipping costs are available at checkout.
Created on:
Tools used
In this video, we are going to replace the rear tail lights on a 2010 Honda Pilot. If you need these parts or other parts for your vehicle, click the link in the description and head over to 1AAuto.com
Open the rear lift gate. Then, we're going to take these two 8 millimeter screws out. Use an 8 millimeter socket and extension and a ratchet. Pull that one out. Now pull the next one out. Pull that out. You can grab the light, we're just going to pull, like that. Those two little pins right here, they're secured in there, so sometimes it takes a little bit of effort to pull it.
The wiring goes through here, just pull that. I'm going to try to feed the connector out here a little bit. This is the connectors there. Then push this little tab right here down on that, and disconnect that, and there's your tail light.
As you can see, this is our old driver's side tail light. This is our new driver's side tail light, from 1AAuto.com. As you can see, just looking at it, it looks brand new compared to the old one. There's a lot of scratches on this that make it hazy. For the bulbs, the configuration is the same, and the reverse light. As you can see on the back side, the wiring harness is the same. Connectors are the same. It has all the same wiring bracketry. Get yours at 1AAuto.com and you'll be ready to rock and roll.
Next we're going to connect this connector right here, so it snaps in. Fish this wire back in here. And then we're going to push this plug in here. You want this to go all the way around so that it seals. Push it. If you need to, you can use a straight blade screwdriver. That's good, like that. Then we're going to, remember, line those pins up with those two holes. Line those two pins up.
Then we'll install these 8 millimeter screws. Use our ratchet extension and 8 millimeter socket and snug these up. Remember, it is plastic, so don't tighten them too tight. The process will be the same on the passenger side.
Thanks for watching. Visit us at 1AAuto.com for quality auto parts, fast and free shipping, and the best customer service in the industry.
Tools used
