Description
Warranty & Shipping
How-To & Tools
Product Reviews
Q&A
Vehicle Fit

Specifications:

  • Fits LH (Driver Side)
  • Replaces dealer part number: 26060-JM70A, 26060JM70A
  • Includes lens & housing
  • Bulbs not included
  • Fits models with Halogen Headlights only
    • Does NOT fit models with Xenon HID (High Intensity Discharge) Headlights
Direct Fit Replacement

Direct fit replacement for OEM assembly

Trouble-free Installation

Uses same wiring as original assembly.  No cutting or splicing required.

DOT and SAE Compliant

Meets federal regulations for on-road use

Part Details

  • Light Option: Halogen

California Customers:

WARNING:  This product can expose you to chemicals including Chromium (Hexavalent Compounds), which is known to the State of California to cause cancer, and birth defects or other reproductive harm.  For more information, go to www.P65Warnings.ca.gov.

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser.

Bulb Note:

Unless otherwise noted, our lights do not include bulbs, though occasionally lighting manufacturers do include bulbs in the lights. If you happen to receive a lighting product (Headlight, Tail light, parking light, fog light etc.) that comes with the bulbs, the bulbs are not covered under our warranty. Our warranty applies only to the light assembly..

  1. step : Removing the Bumper (0:52)
    • Remove the eight plastic clips from the top of the bumper with a trim tool
    • Pry the plastic clip from each wheel liner with a trim tool
    • Remove the 10mm bolt inside each wheel liner
    • Remove the six plastic pins from the bottom of the bumper with a trim tool
    • Remove the three T20 Torx bolts from the bottom of the bumper on each side
    • Disconnect the fog light wiring harnesses if you have fog lights
    • Pull the bumper forward and off the vehicle
  2. step : Removing the Headlight (3:10)
    • Remove the three 10mm bolts from the top of the headlight
    • Remove the 10mm nut from the bottom of the headlight
    • Remove the 10mm bolt from the bottom of the headlight
    • Lift the headlight up and off
    • Disconnect the headlight electrical connectors
  3. step : Installing the Headlight (5:09)
    • Connect the headlight electrical connectors
    • Line up the headlight using the stud
    • Install the three 10mm bolts at the top of the headlight
    • Install the 10mm nut at the bottom of the headlight
    • Install the 10mm bolt at the bottom of the headlight
  4. step : Installing the Bumper (5:54)
    • Lift the bumper into place
    • Pop in the bumper tabs
    • Push the eight plastic clips onto the top of the bumper
    • Insert the 10mm bolt inside each wheel well into the bumper
    • Push the wheel liners into place
    • Push the plastic clip into each wheel liner
    • Install the three T20 screws into each side of the bottom of the bumper
    • Line up the bumper with the air dam
    • Insert the six plastic clips into the bottom of the bumper
  5. step : Aiming the Headlights (7:18)
    • Make a dot at the center of your low beam light with a dry erase marker
    • Measure from the ground to the center of the dot
    • Line up your vehicle with a dark flat surface
    • Mark the center of each headlight on the aiming surface
    • Draw a straight line between the two marks
    • back the vehicle up 25 feet from the aiming surface
    • Turn the headlights on
    • Adjust the passenger side aiming screw until the focus of the passenger side light beam is two inches below the line on the aiming surface
    • Adjust the driver side aiming screw until the focus of the driver side light beam is four inches below the line on the aiming surface

Tools needed for replacement:

    Pliers, Cutters & misc Wrenches

  • Needle nose pliers

  • Ratchets & Related

  • Ratchet
  • Socket Extensions

  • Screwdrivers & Related

  • Flat Blade Screwdriver

  • Sockets - Metric

  • 10mm Socket

  • Specialty Tools

  • Trim Tool Set

  • Torx Drivers & Sockets

  • T20 Torx Driver

There are no reviews for this item.
Will this fit my car? Add a vehicle to make sure
Customer Q&A
Ask a question to 1A Auto customers who purchased the product
No questions have been asked about this item.
Year Make Model Description
2009-2010Nissan Rogue Nissan Rogue Halogen Headlight Driver Side
Only 2 left in stock
Part #: 1ALHL02263


Order must be placed by 4pm ET

Get it in: 2 - 4 Business Days

Want it sooner? Choose Next Day Air at Checkout

How-to Video:

(09:24 min)