Replaces

2006-11 Honda Civic Window Regulator Pair - 1AWRK00922

These window regulators are just what you need to get your vehicle in good working form again!

Specifications:

  • Comes as a PAIR
    • Fits both LH (Driver Side) & RH (Passenger Side) FRONT
  • Power operation
  • Replaces dealer part numbers: 72750-SNA-A03, 72210-SNA-A02, 72210-SNA-A03, 72750SNAA03, 72210SNAA02, 72210SNAA03
  • Include the power window motors
  • Direct replacements
  • Built to strict quality control standards
  • LH (Driver Side) Motor has Auto Up/Down Feature

These window regulators are great replacements that offer good cost savings over the dealer parts!

Please Note: These window regulators are high quality aftermarket parts that meets or exceeds the performance of the original. They have been subjected to extensive testing and quality control standards. That is why we offer these regulators with our superior warranty!

Installation

  • This repair is easier than you may think. You'll find our installation videos helpful. In our experience removing and replacing the door panel is the most involved step in the repair. On most vehicles this only requires removing a few screws and push-in clips.
  • You'll get a great feeling of accomplishment after you complete this repair knowing you saved money, and you didn't have to give up your car for a day at the repair shop. Your passengers and other drivers will be amazed.

Fit guaranteed

  • 1A Auto will refund you with no hassle if this window regulator does not fit the application stated.
  • This regulator will install just as your original does. Save time and money.

Quality

  • Be confident this part will work right. Every regulator is tested after assembly to make sure all mechanisms are working correctly.
  • It is important that your new regulator works for a long period of time. The design of this regulator is tested to withstand 10,000 cycles. That is enough to raise and lower your window 3 times per day for 9 years.

Value

  • Windows that don't work can be frustrating. They can also hurt your vehicles value. An inoperable window could mean $200-$500 discounted off a dealer trade value or asking price.
  • Some shops and dealers charge more for parts and repairs when they think you don't know what is involved. Now you can get the value you deserve. Knowing what this repair entails can be the difference between the value of doing it yourself, or the pain of a costly repair bill.

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser. Please keep your invoice for proof of this warranty.

  1. step : Removing the Door Panel (0:25)
    • Pry up the window switch panel with a flat blade screwdriver
    • Disconnect the switch wiring harnesses
    • Remove the Phillips screw behind the switch panel opening
    • Pry off the trim piece inside the door handle with a flat blade screwdriver
    • Open the push clip with a flat bladed screwdriver
    • Remove the Phillips head screw inside the door handle
    • Pry out the door panel with a door panel clip tool or putty knife
    • Lift the door panel up and off
    • Release the door lock cables with a flat blade screwdriver
    • Remove the plugs from the water shield
    • Disconnect the door lock actuator wiring harness
    • Carefully remove the water shield
  2. step : Removing the Window Regulator (5:30)
    • Loosen the two 10mm bolts that hold the window to the regulator
    • Raise the window by hand
    • Hold the window in place with painter's tape
    • Disconnect the window motor
    • Remove the four 10mm bolts from the regulator
  3. step : Reinstalling the Regulator (8:15)
    • Insert one of the bolts into the window regulator
    • Push the regulator into the door
    • Hang the regulator by its bolt
    • Insert the10mm bolts into the regulator
    • Connect the window motor
    • Remove the painter's tape from the window
    • Lower the window onto the regulator
    • Insert the two 10mm bolts that hold the window to the regulator
  4. step : Installing the Door Panel (11:35)
    • Insert the water barrier into place
    • Press the clips in
    • Connect the door lock actuator
    • Feed the switches into the door panel
    • Connect the door latch cable and close the clip
    • Connect the door lock cable and close the clip
    • Lift the door panel into place
    • Push in the door panel clips
    • Tighten the Phillips screw behind the door handle
    • Slide the hook in
    • Press on the trim piece behind the door handle
    • Tighten the screw behind the switch panel opening
    • Connect the switch panel wiring harnesses
    • Press the switch panel into place

Tools needed for replacement:

    General Tools

  • Razor Blade / Gasket Scraper
  • Pick

  • Ratchets & Related

  • Socket Extensions
  • Ratchet

  • Screwdrivers & Related

  • Flat Blade Screwdriver
  • Phillips Head Screwdriver

  • Sockets - Metric

  • 10mm Socket

  • Specialty Tools

  • Trim Tool Set

There are no reviews for this item. Write Review
Start typing your question and we'll check if it was already asked and answered. Learn More
No questions have been asked about this item. Be the first!

Vehicle Fit

  • 2006-2011 Honda Civic Sedan Front Power Window Regulator with Motor Pair
Part #: 1AWRK00922

Out of Stock

How-to Video:

(15:36 min)