Replaces

2006-11 Chevy HHR Window Regulator Pair Dorman 741-440, 741-441 - 1AWRK00418

These replacement power window regulators with motors are just what you need to get your vehicle in good shape again!

Specifications:

  • Comes as a PAIR
    • Fits both the LH (Driver Side) & RH (Passenger Side) REAR DOORS
  • Power operation
  • Replaces dealer part numbers: 22714333, 22714334
  • Include the power window motors
  • Direct replacements
  • Built to strict quality control standards

These power window regulators with motors make great replacements and have good cost savings over dealer units.

Please Note: These window regulators are high quality aftermarket parts that meets or exceeds the performance of the original. They have been subjected to extensive testing and quality control standards. That is why we offer these regulators with our superior warranty!

Installation

  • This repair is easier than you may think. You'll find our installation videos helpful. In our experience removing and replacing the door panel is the most involved step in the repair. On most vehicles this only requires removing a few screws and push-in clips.
  • You'll get a great feeling of accomplishment after you complete this repair knowing you saved money, and you didn't have to give up your car for a day at the repair shop. Your passengers and other drivers will be amazed.

Fit guaranteed

  • 1A Auto will refund you with no hassle if this window regulator does not fit the application stated.
  • This regulator will install just as your original does. Save time and money.

Quality

  • Be confident this part will work right. Every regulator is tested after assembly to make sure all mechanisms are working correctly.
  • It is important that your new regulator works for a long period of time. The design of this regulator is tested to withstand 10,000 cycles. That is enough to raise and lower your window 3 times per day for 9 years.

Value

  • Windows that don't work can be frustrating. They can also hurt your vehicles value. An inoperable window could mean $200-$500 discounted off a dealer trade value or asking price.
  • Some shops and dealers charge more for parts and repairs when they think you don't know what is involved. Now you can get the value you deserve. Knowing what this repair entails can be the difference between the value of doing it yourself, or the pain of a costly repair bill.

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser. Please keep your invoice for proof of this warranty.

  1. step : Removing the Door Panel (1:05)
    • Remove the rubber grommet in the door pull
    • Remove the trim piece in the door handle
    • Remove the T30 screws in the door pull
    • Remove the T30 screw in the door handle
    • Remove the two retaining clips on the back of the door panel
    • Pry out the door panel with a door panel clip tool or putty knife
    • Lift the door panel up and off
    • Disconnect the latch cables from the door handle
    • Pry out the window switch with a flat blade screwdriver
  2. step : Removing the Window Regulator (3:28)
    • Carefully peel back the water shield
    • Hold the water shield with painter's tape
    • Loosen the two 10mm bolts that hold the window to the regulator
    • Raise the window by hand
    • Hold the window in place with painter's tape
    • Remove the three 10mm bolts from the window regulator
    • Pull the window regulator out through the door
    • Disconnect the window motor lead
  3. step : Installing the Window Regulator (6:20)
    • Connect the window motor lead
    • Insert one of the bolts into the window regulator
    • Push the regulator into the door
    • Hang the regulator by its bolt
    • Insert the three 10mm bolts into the regulator
    • Test the window regulator with the master switch
    • Remove the painter's tape from the window
    • Lower the window onto the regulator
    • Insert the two 10mm bolts that hold the window to the regulator
    • Remove the painter's tape from the water shield
    • Put the water shield into place
  4. step : Installing the Door Panel (8:36)
    • Pop the window switch in place
    • Connect the latch cables to the door handle
    • Lift the door panel into place
    • Push in the door panel clips
    • Insert the T30 screw in the door handle
    • Insert the T30 screws in the door pull
    • Insert the two retaining clips on the back of the door panel
    • Replace the rubber grommet in the door pull
    • Replace the trim piece in the door handle
    • For more detailed instructions, please see the 2008 HHR window regulator replacement video

Tools needed for replacement:

    General Tools

  • Putty Knife

  • Materials, Fluids, and Supplies

  • Painter's Tape

  • Ratchets & Related

  • Ratchet

  • Screwdrivers & Related

  • Flat Blade Screwdriver

  • Sockets - Metric

  • 10mm Socket

  • Specialty Tools

  • Door Panel Removal Tool

  • Torx Drivers & Sockets

  • T30 Torx Bit

There are no reviews for this item. Write Review
Start typing your question and we'll check if it was already asked and answered. Learn More
No questions have been asked about this item. Be the first!

Vehicle Fit

  • 2006-2011 Chevy HHR Rear Power Window Regulator with Motor Pair Dorman 741-440, 741-441

This part replaces:

  • Dorman 741-440,741-441
  • Dorman 741-440, 741-441
Only 2 left in stock
Part #: 1AWRK00418

Ships Same Day for orders placed by 4 P.M. ET

Dorman
Brand #: 741-440, 741-441

How-to Video:

(09:30 min)