This is a direct replacement tail light pair for your vehicle. It installs just as your original does. If your stop light has been damaged broken or cracked this rear light will fix the problem.

Tail light specifications:

  • Comes as a PAIR:
    • Includes both the LH (Driver Side) & RH (Passenger Side)
  • Assembly includes lens and housing
  • Department of Transportation (DOT) & Society of Automotive Engineers (SAE) approved
  • Bulbs and wiring not included

Direct Fit Replacement

Direct fit replacement for OEM assembly

Trouble-free Installation

Uses same wiring as original assembly.  No cutting or splicing required.

DOT and SAE Compliant

Meets federal regulations for on-road use

Part Details

  • Quantity: Pair

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser.

  1. step : Removing the Outer Tail Light (0:22)
    • Remove the screw from the trunk trim with a flat blade screwdriver
    • Pop the plastic retainers on the wiring harness off of the bolt studs
    • Disconnect the wiring harnesses
    • Remove the 8mm bolts from the light
  2. step : Removing the Rear Bumper Cover (2:00)
    • Pry out the two push clips from underneath the bumper
    • Remove the Phillips screw from the fender liner
    • Open the trunk
    • Remove the flat head bolts in the bumper with a 5mm Allen bit
    • Firmly pull the bumper cover out of the clips
    • Remove the Phillips head screw from the bottom of the light
    • Pull the light pins on the light out of the bracket
  3. step : Transferring the Bulbs (6:30)
    • Twist the bulb socket counterclockwise out of the light
    • Twist the bulb clockwise into the light
  4. step : Installing the Rear Bumper Cover (7:28)
    • Insert the light into place
    • Tighten the Phillips screw to the bottom of the light
    • Line up the bumper cover
    • Snap the clips into place
    • Tighten the flat head bolts in the bumper with a 5mm Allen bit
    • Tighten the Phillips screws to the fender liner
    • Push in the two push clips underneath the bumper
  5. step : Installing the Outer Tail Light (10:11)
    • Tighten the 8mm bolts to the light
    • Connect the wiring harnesses
    • Pop the plastic retainers onto the bolt studs
    • Tighten the screw into the trunk trim with a flat blade screwdriver

Tools needed for replacement:

    Allen Wrenches

  • 5mm Allen Wrench

  • Pliers, Cutters & misc Wrenches

  • Needle nose pliers

  • Ratchets & Related

  • Socket Extensions
  • Ratchet

  • Screwdrivers & Related

  • Flat Blade Screwdriver
  • Phillips Head Screwdriver

  • Sockets - Metric

  • 8mm Socket

  • Specialty Tools

  • Trim Tool Set

There are no reviews for this item. Write Review
Start typing your question and we'll check if it was already asked and answered. Learn More
No questions have been asked about this item. Be the first!

Vehicle Fit

  • 2006-2008 Honda Civic Sedan Tail Light Pair

This part replaces:

  • OE # 33501SNAA02
  • OE # 33551SNAA01
  • Partslink HO2801165, HO2800166
Part #: 1ALTP00324

Out of Stock

How-to Video:

(11:32 min)