Replaces

2005-10 Pontiac G6 Window Regulator Driver Side Front - 1AWRG02190

This replacement window regulator is just what you need to get your vehicle in good shape again!

Specifications:

  • LH (Driver Side) FRONT
  • Does not include motor. Buyer will need to reuse original motor
  • Replaces dealer part numbers: 15861474, 25931991
  • Direct replacement
  • Built to strict quality control standards
  • Fits 4 Door Sedan models only

This window regulator makes a great replacement and has good cost savings over a dealer unit.

 

Please Note:  This window regulator is designed to work with factory style motors only.  Due to variations in aftermarket designs, replacement motors may not have the correct gear style.

Please Note: This window regulator is a high quality aftermarket part that meets or exceeds the performance of the original.  It has been subjected to extensive testing and quality control standards.  That is why we offer this regulator with our superior warranty!

Installation

  • This repair is easier than you may think. You'll find our installation videos helpful. In our experience removing and replacing the door panel is the most involved step in the repair. On most vehicles this only requires removing a few screws and push in clips.
  • You'll get a great feeling of accomplishment after you complete this repair knowing you saved money, and you didn't have to give up your car for a day at the repair shop. Your passengers and other drivers will be amazed.

Fit guaranteed

  • 1A Auto will refund you with no hassle, if this Window regulator does not fit the application stated.
    •  This Regulator will install just as your original does. Save time and money.

Quality

  • Be confident this part will work right. Every regulator is tested after assembly to make sure all mechanisms are working correctly.
  • It is important that your new regulator works for a long period of time. The design of this regulator is tested to withstand 10,000 cycles. That is enough to raise and lower your window 3 times per day for 9 years.
  • Nothing is more frustrating than taking your car apart and finding the part you purchased does not fit. You want the part to fit. This design is test fit on an actual door. When you install it, you will have no issues.

Value

  • Windows that don't work can be frustrating. They can also hurt your vehicles value. An inoperable window could mean $200-$500 discounted off a dealer trade value or asking price.
  • Some shops and dealers charge more for parts and repairs when they think you don't know what is involved. Now you can get the value you deserve. Knowing what this repair entails can be the difference between the value of doing it yourself, or the pain of a costly repair bill.

2 Year Warranty

This item is backed by a 2 Year Warranty. In the event this item should fail during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser. Please keep your invoice for proof of this warranty.

  1. step : Removing the Door Panel (0:41)
    • Pry off the trim piece inside the door handle with a flat blade screwdriver
    • Remove the T30 Torx screw inside the door handle
    • Pull out the door handle
    • Disconnect the latch cables from the door handle
    • Disconnect the lock wiring harness with a flat blade screwdriver
    • Push in the center of the rivet on the side of the door panel and pry out the side of the rivet with a flat blade screwdriver
    • Pry off the trim piece inside the door pull with a flat blade screwdriver
    • Remove the two T30 Torx screws inside the door pull
    • Pry up the window switch panel by hand
    • Disconnect the wiring harnesses
    • Pry out the door panel with a door panel clip tool or putty knife
    • Lift the door panel up and off
    • Carefully peel off the water shield
  2. step : Removing the Window Regulator (3:30)
    • Loosen the two 10mm bolts that hold the window to the regulator
    • Raise the window by hand
    • Hold the window in place with painter's tape
    • Peel back the adhesive squares near the top of the door
    • Disconnect the window motor lead
    • Remove the five 10mm bolts from the regulator
    • Pull the window regulator out through the door
  3. step : Installing the New Regulator (5:38)
    • Insert one of the bolts into the window regulator
    • Push the regulator into the door
    • Insert and tighten the five 10mm bolts into the regulator
  4. step : Testing the Regulator (6:37)
    • Connect the window motor lead
    • Connect the window switch wiring harness
    • Turn the vehicle on
    • Run the motor up for 4 seconds
    • Disconnect the window motor lead
  5. step : Installing the New Regulator (6:44)
    • Remove the painter's tape from the window
    • Lower the window onto the regulator
    • Insert the two 10mm bolts that hold the window to the regulator
    • Replace the adhesive squares
  6. step : Reinstalling the Door Panel (7:34)
    • Put the water shield into place
    • Lift the door panel into place
    • Push in the door panel clips
    • Connect the wiring harnesses to the switch panel
    • Push the switch panel into place
    • Tighten the two T30 Torx screws inside the door pull
    • Push in the trim piece inside the door pull
    • Push in the rivet on the edge of the door panel
    • Connect the door lock wiring harness to the door handle
    • Connect the latch cables to the door handle
    • Push in the door handle
    • Tighten the T30 Torx screw inside the door handle
    • Push in the trim piece inside the door handle

Tools needed for replacement:

    General Tools

  • Putty Knife

  • Ratchets & Related

  • Ratchet

  • Screwdrivers & Related

  • Flat Blade Screwdriver

  • Sockets - Metric

  • 10mm Socket

  • Torx Drivers & Sockets

  • T30 Torx Driver

There are no reviews for this item. Write Review
Start typing your question and we'll check if it was already asked and answered. Learn More
No questions have been asked about this item. Be the first!

How-to Video:

(09:30 min)

Tools List:

    General Tools

  • Putty Knife

  • Ratchets & Related

  • Ratchet

  • Screwdrivers & Related

  • Flat Blade Screwdriver

  • Sockets - Metric

  • 10mm Socket

  • Torx Drivers & Sockets

  • T30 Torx Driver



This part replaces:

  • OE # 15861474
  • OE # 25931991
  • Hollander 125-02159L

Vehicle Fit

  • 2005-2010 Pontiac G6 4 Door Sedan Power Window Regulator without Motor Front Driver Side (High Quality)
Only 4 left in stock
Part #: 1AWRG02190

Ships Same Day for orders placed by 4 P.M. ET

We're here to help

1A Auto Parts

Customer Feedback

"Thanks for the fast reliable service. Great price, and the headlights were as good as oem or better!!! Keep up the good work..."
- Dwuan M.
Read More