Replaces
Frequently bought together
Assemblies may include halogen or incandescent test bulbs that should be replaced before installation.
Features and Benefits
Item Condition:
New
Attention California Customers:
WARNING: This product can expose you to chemicals including Chromium (Hexavalent Compounds), which is known to the State of California to cause cancer, and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov
This item is backed by our limited lifetime warranty. In the event this item should fail due to manufacturing defects during intended use, we will replace the part free of charge. This warranty covers the cost of the part only.
The bulbs are for testing and not covered under our warranty. Our warranty applies to the light assembly only.
FREE Shipping is standard on Orders shipped to the lower 48 States (Contiguous United States). Standard shipping charges apply to Hawaii, Alaska and US Territories. Shipping is not available to Canada.
Expedited is available on checkout to the United States, excluding Alaska, Hawaii and US Territories as well as P.O. Boxes and APO/FPO/DPO addresses. Final shipping costs are available at checkout.
Created on:
Tools used
Brought to you by 1AAuto.com, your source for quality replacement parts and the best service on the internet. In this video, I'm going to show you how to remove and replace a taillight on this 2005 Toyota Camry same as most Camry's of this era. The only tools you'll need are a 10mm socket and ratchet or a wrench and a Phillips screw driver.
If you're just looking to change the light bulbs in your taillights, open up your trunk. There's a little access door in this insulation. You can see your lights. They just twist counterclockwise and pull out. Then, the bulbs come out and push back in. If you're looking to replace your taillight because it's been broken, you'll want to remove this Phillips screw here first. This little screw just pops out. I'll put it right up here. Then, this whole panel put your hand in behind. Push it out at the bottom and off. You just need to make yourself a little bit of room. Now, your trim here, you just have to pull it out and around that hook. Here, you can see one, two and three 10mm bolts. Then, right down here is your connector. You just push on this tab, then pull this up and out. Let's see if I can do it here. Okay, it's disconnected.
Once you remove those 10mm nuts, bring the inside out first. Then, it comes right out. Here is our original and the new light from 1A Auto. You can see the new light from 1A Auto is going to go in. It's got the correct plug and everything. It's going to fit right in there and fix your problem. This lights fine so I'm going to reinstall it in the car. Put the harness down through the lower hole. Start your outer one in first. If you look right down in, you can see easily. Start that one in and push the whole thing right in. Pull your insulation back and put the three 10mm nuts on. Okay, plug your harness back in. Put your insulation up in place. Then, you just hook it right around like that right there. You may want to bring this up. There are little pins in your plastic here so just pull it up and on. There should be a clip right down here. Then, we install this.
We hope this helps you out. Brought to you by www.1AAuto.com, your source for quality replacement parts and the best service on the internet. Please feel free to call us toll-free, 888-844-3393. Were the company that's here for you on the internet and in person.
