Replaces
2005-06 Toyota Camry Tail Light - 1ALTL00554
1ALTL00554This replacement Toyota Camry tail light is just what you need to get your Toyota in good looking form again!
This tail light features:
- Left Hand Driver side
- Replaces dealer Part Number: 81560-06230
- Mounts on 1/4 panel
- Assembly includes lens and housing
- Department of Transportation (DOT) & Society of Automotive Engineers (SAE) approved
- Direct replacement
- Fits USA built SE models only
- Built to strict quality control standards
- Bulbs and wiring not included
This Toyota Camry tail light makes a great replacement and has good cost savings over a dealer unit.
Direct Fit Replacement
Direct fit replacement for OEM assembly
Trouble-free InstallationLight uses same wiring as the original assembly, providing easy, trouble-free installation. No cutting or splicing required.
DOT and SAE CompliantDOT & SAE compliant: meets federal regulations for on-road use
Lifetime Warranty
This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser. Please keep your invoice for proof of this warranty.
Bulb Note:
Unless otherwise noted, our lights do not include bulbs, though occasionally lighting manufacturers do include bulbs in the lights. If you happen to receive a lighting product (Headlight, Tail light, parking light, fog light etc.) that comes with the bulbs, the bulbs are not covered under our warranty. Our warranty applies only to the light assembly.
-
step : Remove the tail light (0:23)
- Pop open the trunk.
- Flip open the access panel to service your bulbs.
- Remove the Phillips screw in your trunk accessory hook.
- Peel back the upholstery.
- Unbolt the three 10 mm nuts and disconnect the wiring harness.
- Remove the tail light from the vehicle.
-
step : Install the new tail light (2:19)
- Thread the wiring through the rear of the car and mount the tail light.
- Install the tail light by bolting down the three 10 mm bolts.
- Connect the wiring harness and bulbs.
- Replace the upholstery and secure with the Phillips screw and accessory hook.
- Close the trunk.
Tools needed for replacement:
- Ratchet
- Phillips Head Screwdriver
- 10mm Socket
Ratchets & Related
Screwdrivers & Related
Sockets - Metric
Vehicle Fit
- 2005-2006 Toyota Camry SE (US Built Models) Tail Light Driver Side
This part replaces:
- Partslink TO2800156
- Hollander 166-59915AL
- OE # 8156006230
- TYC 11-6066-90-1
- DEPO 312-1958L-AF2