Replaces
2004-09 Nissan Quest Steering & Suspension Kit - 1ASFK04762
1ASFK04762Specifications:
- Brand New Steering & Suspension Kit
- Comes as an 8 Piece Kit
- Fits LH (Driver Side) & RH (Passenger Side)
- Direct replacements
- Built to strict quality control standards
Our steering and suspension components are sealed for long life and do not require the extra maintenance typically required by greasable versions.
Please Note: Whenever replacing steering components, it is highly recommended to have a professional alignment performed on the vehicle afterwards. Failure to do so may result in issues with steering and premature tire wear.
Direct FitAll parts are direct fit, application-specific parts with no modifications required
Rigorously TestedRigorously tested and made from higher quality materials than the competition. Our parts are built to have a longer life in any environment or road conditions.
State of the Art ManufacturingOur parts are manufactured by some of the same factories that the OEMs use.
Prepackaged for Your ConvenienceOur kits have been carefully put together to include all of the parts you need to get the job done, saving you both time and money. These kits also help take the guesswork out of finding the correct part for your vehicle’s steering or suspension system, allowing you to get started on your repair project faster.
Lifetime Warranty
This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser. Please keep your invoice for proof of this warranty.
-
step : Removing the Wheel (0:58)
- Loosen the 19mm lug nuts with the vehicle on the ground
- Raise the vehicle with a floor jack
- Secure the vehicle on jack stands
- Remove the lug nuts
- Pull off the wheel
-
step : Removing the Stabilizer Link (1:35)
- Turn the wheel by hand
- Clean off the threads with rust penetrant and a wire brush if necessary
- Hold the lower stabilizer link stud with a 14mm wrench
- Remove the nut from the stabilizer link with a 15mm hex socket
- If the nut strips out, hold it in place with locking pliers and sawzall it off
-
step : Reinstalling the Stabilizer Link (3:41)
- Push the stabilizer link into place
- Start the nuts by hand
- Tighten the nuts
- Torque the nuts to 29 foot-pounds
-
step : Reattaching the Wheel (4:19)
- Slide the wheel into place
- Start the lug nuts by hand
- Tighten the 19mm lug nuts preliminarily
- Lower the vehicle to the ground
- Tighten the lug nuts to 80 foot-pounds in a crossing or star pattern
Tools needed for replacement:
- 5mm Allen Wrench
- Sawzall
- Ratchet
- Socket Extensions
- 1/2 Inch Breaker Bar
- 19mm Socket
- 14mm Wrench
Allen Wrenches
General Tools
Ratchets & Related
Sockets - Metric
Wrenches - Metric
Vehicle Fit
- 2004-2009 Nissan Quest 8 Piece Set Steering & Suspension Kit
This part replaces:
- Moog K500129
- OE # 48520CK025
- OE # 48521CK000
- OE # 54668CA000, 54668CK000
- OE # 54618CA000, 54618CK000
- Moog K80255
- Moog K80256
- Moog EV800227
- Moog ES800404