2004-08 Pontiac Grand Prix Tail Light - 1ALTL00410

This replacement tail light is just what you need to get your Pontiac Grand Prix in good looking form again!

This tail light features the following specifications:

• RH Passenger side
• Replaces dealer part number: 15212482
• DOT (Department of Transportation) & SAE (Society of Automotive Engineers) approved
• Direct replacement
• Built to strict quality control standards

We have noticed that there are many inferior quality Tail lights on the market. We have researched other tail light manufacturers and are only selling what we believe to be the highest quality, best fitting, aftermarket tail lights available. So don't be fooled by cheaper made imitation tail lights. Go with superior quality!

This light makes a great replacement and has good cost savings over a dealer unit.

Bulb Note:

Unless otherwise noted, our lights do not include bulbs, though occasionally lighting manufacturers do include bulbs in the lights. If you happen to receive a lighting product (Headlight, Tail light, parking light, fog light etc.) that comes with the bulbs, the bulbs are not covered under our warranty. Our warranty applies only to the light assembly.

Direct fit replacement for OEM assembly

Uses same wiring as original assembly.  No cutting or splicing required.

Meets federal regulations for on-road use

Item Condition: New

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser.

step : Removing the Taillight Assembly (0:48)

• Remove the thumb screw.
• Pull back the insulation.
• Remove the two thumb screws.
• Pull the taillight out and off.
• Disconnect the harness.

step : Replacing the Bulbs (2:31)

• Twist the socket out.
• The bulb pulls straight out.
• The new bulb pushes in.
• Twist the socket back in.

step : Replacing the Taillight Assembly (2:56)

• Reconnect the harness.
• Line up the taillight and push it into place.
• Replace the two thumb screws on the back.
• Replace the insulation.
• Replace the last thumb screw.