Specifications:

  • Comes as a PAIR
    • Fits both the LH (Driver Side) & RH (Passenger Side) FRONT DOORS
  • Power operation
  • Includes power window motors which are already installed
  • Direct replacements
  • Built to strict quality control standards
  • 100% tested prior to leaving the factory

Please Note: These window regulators are high quality aftermarket parts that meets or exceeds the performance of the original. They have been subjected to extensive testing and quality control standards. That is why we offer these regulators with our superior warranty!

Installation

  • This repair is easier than you may think. You'll find our installation videos helpful. In our experience removing and replacing the door panel is the most involved step in the repair. On most vehicles this only requires removing a few screws and push-in clips.
  • You'll get a great feeling of accomplishment after you complete this repair knowing you saved money, and you didn't have to give up your car for a day at the repair shop. Your passengers and other drivers will be amazed.

Fit guaranteed

  • 1A Auto will refund you with no hassle if this window regulator does not fit the application stated.
  • This regulator will install just as your original does. Save time and money.

Quality

  • Be confident this part will work right. Every regulator is tested after assembly to make sure all mechanisms are working correctly.
  • It is important that your new regulator works for a long period of time. The design of this regulator is tested to withstand 10,000 cycles. That is enough to raise and lower your window 3 times per day for 9 years.

Value

  • Windows that don't work can be frustrating. They can also hurt your vehicles value. An inoperable window could mean $200-$500 discounted off a dealer trade value or asking price.
  • Some shops and dealers charge more for parts and repairs when they think you don't know what is involved. Now you can get the value you deserve. Knowing what this repair entails can be the difference between the value of doing it yourself, or the pain of a costly repair bill.

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser. Please keep your invoice for proof of this warranty.

  1. step : Removing the Door Panel (0:46)
    • Disconnect the negative battery cable
    • Using a flat blade screwdriver pry up the switch panel
    • Pry out the red tab and disconnect the harness
    • Remove the two Phillips screws (behind the door handle and pull handle)
    • Using a clip removal tool or putty knife pry the clips around the door panel
    • Lift the door panel up and off
    • Disconnect the lock rod
    • Disconnect the door lock switch.
  2. step : Accessing the Power Window Regulator (2:37)
    • Remove the four Phillips screws around the speaker
    • Remove the speaker and disconnect the harness
    • Carefully remove the water shield
  3. step : Removing the Power Window Regulator (3:02)
    • Pry out on the plastic rivet from the front with a large screwdriver and push the teeth with a smaller screwdriver to remove it
    • Disconnect the connection
    • Loosen the T30 Torx bolts on both sides of the window
    • Lift the window free from the regulator and tape it up
    • Loosen the bottom bolts on the regulator and remove the top two bolts
    • Pull the rail free from the door
  4. step : Installing a New Power Window Regulator (8:29)
    • Feed the regulator down and in to the door
    • Replace the top bolts and tighten the bottom the two bolts
    • Put the bolts that come with the window regulator into the place of the plastic rivets
    • Remove the tape from the window and lower it down into the regulator clamps
    • Tighten the T30 bolts on the window clamps
    • Plug the switch panel in and test the window
    • Disconnect the switch panel
  5. step : Reassembling the Door (12:10)
    • Replace the water shield. Use painters tape if it fails to stick
    • Reconnect the speaker and reinsert the four Phillips screws
    • Reconnect the door handle rod on the door panel. Lock it into place
    • Plug in the door lock lead
    • Line up the door panel
    • Push it down and into place
    • Lock the pins in around the door panel
    • Reconnect the switch panel and snap the panel into place.
    • Replace the two Phillips screws in the door panel.
    • Reconnect your negative battery cable.

Tools needed for replacement:

    General Tools

  • Putty Knife

  • Materials, Fluids, and Supplies

  • Painter's Tape

  • Screwdrivers & Related

  • Phillips Head Screwdriver
  • Flat Blade Screwdriver

  • Torx Drivers & Sockets

  • T30 Torx Driver

  • Wrenches - Metric

  • 12mm Wrench

5.0 / 5.0
1 Review
5 Stars
4 Stars
3 Stars
2 Stars
1 Stars
1
0
0
0
0
Great product easy to install. Will buy parts here in the future.
July 11, 2017
Purchased
9 months ago
Start typing your question and we'll check if it was already asked and answered. Learn More
No questions have been asked about this item. Be the first!

Vehicle Fit

  • 2004-2007 Chrysler Town & Country Front Power Window Regulator with Motor Pair
  • 2004-2007 Dodge Caravan Front Power Window Regulator with Motor Pair
  • 2004-2007 Dodge Grand Caravan Front Power Window Regulator with Motor Pair

This part replaces:

  • Partslink CH1350129
  • Partslink CH1351129
  • Hollander 125-02127R
  • Hollander 125-02128L
  • OE # 4894527AA
  • Dorman 741-535
  • Dorman 741-534
  • OE # 4894526AA
Part #: 1AWRK00378



How-to Video:

(14:05 min)