Replaces
Assemblies may include halogen or incandescent test bulbs that should be replaced before installation.
Features and Benefits
Item Condition:
New
Attention California Customers:
WARNING: This product can expose you to chemicals including Chromium (Hexavalent Compounds), which is known to the State of California to cause cancer, and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov
This item is backed by our limited lifetime warranty. In the event this item should fail due to manufacturing defects during intended use, we will replace the part free of charge. This warranty covers the cost of the part only.
The bulbs are for testing and not covered under our warranty. Our warranty applies to the light assembly only.
FREE Shipping is standard on Orders shipped to the lower 48 States (Contiguous United States). Standard shipping charges apply to Hawaii, Alaska and US Territories. Shipping is not available to Canada.
Expedited is available on checkout to the United States, excluding Alaska, Hawaii and US Territories as well as P.O. Boxes and APO/FPO/DPO addresses. Final shipping costs are available at checkout.
Created on:
Tools used
Take a Phillips-head screwdriver. Take these two screws out. And you just grab the light assembly and just slide it straight out. Should be some pins right here that are holding in the front part of it. Take the lights out. There's a little lock right here. Just push down on the lock and then twist. Slide it out. Same for the other ones.
It's always a good idea to replace the light bulbs when you're replacing the lens. Just pull the light bulb straight out. Line the new one up. Lock it in place. Do the same with the other two.
Now, take the light sockets, line them up. This one goes in the bottom. Lock it in place. The reverse light, lock it in. And the marker and turn signal, lock it in place.
Now, these pins are gonna line up with those two holes. So, line those up, and just push it in place. Now take the screws. Get them both started and tighten them down. And snug it down, and you're good.
Tools used
Now take a Philips head screwdriver. Take these two screws out. And just grab the light assembly, slide it out. Slide this wire right off this retainer, and twist the sockets to the left, counterclockwise, and slide them out. Now just take the light sockets. You can replace the bulbs, if you want to. And twist it clockwise. And line them up. And there's two tabs go into the body. Put the wire right there. Line that up. Put the screws in. Get them both started, and take the screwdriver, and snug them up.
