This replacement Nissan Sentra Tail light for the Base & S models is just what you need to get your Nissan in good looking form again!


  • RH (Passenger Side)
    • Quarter (1/4) panel mounted
  • Replaces dealer part number: 26550-6Z525, 265506Z525
  • Injection molded plastic
  • DOT (Department of Transportation) & SAE (Society of Automotive Engineers) approved
  • Direct replacement
  • Does not include bulbs or wiring
  • Does not fit SE-R and SE-R SPEC V models

We have noticed that there are many inferior quality Tail lights on the market. We have researched other Tail light manufacturers and are only selling what we believe to be the highest quality, best fitting, aftermarket Tail lights available. So don't be fooled by cheaper made imitation Tail lights. Go with superior quality!

This Nissan Sentra taillamp is a great replacement and has good cost savings over a taillamp from the dealer.

Direct Fit Replacement

Direct fit replacement for OEM assembly

Trouble-free Installation

Light uses same wiring as the original assembly, providing easy, trouble-free installation.  No cutting or splicing required.

DOT and SAE Compliant

DOT & SAE compliant: meets federal regulations for on-road use

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser. Please keep your invoice for proof of this warranty.

Bulb Note:

Unless otherwise noted, our lights do not include bulbs, though occasionally lighting manufacturers do include bulbs in the lights. If you happen to receive a lighting product (Headlight, Tail light, parking light, fog light etc.) that comes with the bulbs, the bulbs are not covered under our warranty. Our warranty applies only to the light assembly.

  1. step : Changing a Bulb (0:54)
    • Pry out the clip behind the taillight.
    • Pull the insulation down.
    • Twist the sockets counterclockwise.
    • Push the bulb in and twist counterclockwise to remove.
    • Push a new bulb in clockwise.
    • Twist the socket back in clockwise.
  2. step : Removing the Taillight Assembly (1:47)
    • Disconnect the taillight harness.
    • Remove the harness clips from the car.
    • Remove the four 8mm nuts.
    • Push the taillight out and off.
    • Scrape off the seal.
  3. step : Replacing the Taillight Assembly (3:39)
    • Replace the seal starting at the bottom.
    • Line up the taillight and push it into place.
    • Replace the four 8mm nuts.
    • Re-clip the harness to the car.
    • Reconnect the harness.
    • Push the insulation into place.
    • Replace the clip.

Tools needed for replacement:

    General Tools

  • Putty Knife

  • Ratchets & Related

  • Socket Extensions
  • Ratchet

  • Screwdrivers & Related

  • Flat Blade Screwdriver

  • Sockets - Metric

  • 8mm Socket

5.0 / 5.0
1 Review
5 Stars
4 Stars
3 Stars
2 Stars
1 Stars
Quick and easy install
Gathered the three tools listed, followed the instructional video, and replaced old cracked one in no time. All while 32 weeks prego! You cannot tell the difference between my original driver side one and the replaced passenger side. Saved a ton order online and replacing it myself.
March 9, 2016
Response from 1A Auto
Congratulations on the addition to your family! We love to hear do it yourself tales!
March 10, 2016
Derek C Staff
Start typing your question and we'll check if it was already asked and answered. Learn More
No questions have been asked about this item. Be the first!

Vehicle Fit

  • 2004-2006 Nissan Sentra Base Model Outer Tail Light Passenger Side
  • 2004-2006 Nissan Sentra S Outer Tail Light Passenger Side

This part replaces:

  • Partslink NI2801159
  • Hollander 166-59604R
  • OE # 265506Z525
  • TYC 11-6001-00-1
  • DEPO 315-1946R-AFD
Part #: 1ALTL00424

Ships Same Day for orders placed by 4 P.M. ET

How-to Video:

(07:06 min)