2003-07 Cadillac CTS Window Regulator - 1AWRG02598

Warranty & Shipping
How-To & Tools
Product Reviews
Vehicle Fit

Part Details

  • Regulator Option:   without Motor
  • Operation:   Power


  • Fits LH (Driver side) Front Door
  • Direct replacement
  • Built to strict quality control standards
  • Does not include motor. Buyer will need to reuse original motor

Please Note:

This window regulator is designed to work with factory style motors only.  Due to variations in aftermarket designs, replacement motors may not have the correct gear style.

Please Note:

This window regulator is a high quality aftermarket part that meets or exceeds the performance of the original. It has been subjected to extensive testing and quality control standards. That is why we offer this regulator with our superior warranty!

Rigorously Tested

Build to strict quality standards

Highest Quality Materials

Made from the highest quality materials for extreme durability and premium performance.

Item Condition: New

Attention California Customers:

WARNING:  This product can expose you to chemicals including Lead and Lead Compounds, which are known to the State of California to cause cancer, and birth defects or other reproductive harm.  For more information, go to

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser.

  1. step : Removing the Door Panel (0:33)
    • Pry off the door handle bezel with a putty knife
    • Pull up on the tab and disconnect the lock connecter
    • Pry out on the corner of the lock button with a putty knife and remove it
    • Remove the panel from behind the door pull with a putty knife
    • Remove the two Phillips head screws inside the door pull
    • Pry off the trim piece at the front top corner of the door panel
    • Pry out the door panel by hand
    • Lift the door panel up and off
    • Remove the pins from the control panel with a pair of pliers
    • Remove the 10mm bolt from the door handle
    • Slide the panel forward and off the latch rod
    • Remove the mirror clip and carefully peel the water shield
  2. step : Removing the Window Regulator (3:47)
    • Remove the two 10mm nuts from the regulator
    • Raise the window by hand
    • Hold the window in place with painter's tape
    • Disconnect the window motor lead
    • Remove the five 10mm bolts from the regulator and motor assembly
    • Pull the window regulator out through the door
  3. step : Preparing the New Window Regulator (6:40)
    • Remove the T30 Torx screws from the window motor
    • Transfer the window motor to the new regulator
    • Replace and tighten the T30 Torx screws
  4. step : Installing the New Window Regulator (7:43)
    • Insert two of the bolts into the window regulator
    • Push the regulator into the door
    • Hang the regulator by its bolt
    • Insert the five 10mm bolts into the regulator and motor assembly
    • Reconnect the window motor lead
    • Remove the painter's tape from the window
    • Slowly lower the window onto the regulator
    • Insert the two 10mm bolts that hold the window to the regulator
  5. step : Replacing the Door Panel (11:00)
    • Put the water shield into place with the door latch rod through the shield
    • Place the control panel on and replace the pins
    • Reattach the door handle and connect the latch rod
    • Replace and tighten the 10mm bolt on the door handle
    • Align the door panel
    • Push in the door panel clips in
    • Replace and tighten the two Phillips head screws inside the door pull
    • Attach the panel from behind the door pull
    • Re-clip the door handle bezel
    • Insert and re-clip the door lock connector

Tools needed for replacement:

    General Tools

  • Putty Knife

  • Materials, Fluids, and Supplies

  • Painter's Tape

  • Pliers, Cutters & misc Wrenches

  • Needle nose pliers

  • Ratchets & Related

  • Ratchet
  • Socket Extensions

  • Screwdrivers & Related

  • Phillips Head Screwdriver

  • Sockets - Metric

  • 10mm Socket

  • Torx Drivers & Sockets

  • T30 Torx Driver

There are no reviews for this item.
Will this fit my car? Add a vehicle to make sure
Customer Q&A
Ask a question to 1A Auto customers who purchased the product
No questions have been asked about this item.
Year Make Model Description
2003-2007Cadillac CTS Cadillac CTS Front Power Window Regulator without Motor Driver Side
Part #: 1AWRG02598

Order must be placed by 4pm ET
Delivery options for:

Estimated Arrival Cost

Deliveries made to PO Boxes and FPO may take longer. See our Shipping & Delivery for more information.

Get it in: 2 - 4 Business Days

Want it sooner? Choose Next Day Air at Checkout

How-to Video:

(13:30 min)