2003-05 Honda Civic Tail Light - 1ALTL01479

This replacement Tail light is just what you need to get your vehicle in good looking form again!

Specifications:

• RH (Passenger Side) INNER
  • Mounts on the trunk lid
  • Includes reverse lamp
• Replaces dealer part number: 34151-S5B-A01, 34151S5BA01
• Includes lens & housing
• DOT (Department of Transportation) & SAE (Society of Automotive Engineers) approved
• Direct replacement
• Fit 4 door Sedan models only

This Tail light makes a great replacement and has good cost savings over a dealer unit.

Bulb Note:

Unless otherwise noted, our lights do not include bulbs, though occasionally lighting manufacturers do include bulbs in the lights. If you happen to receive a lighting product (Headlight, Tail light, parking light, fog light etc.) that comes with the bulbs, the bulbs are not covered under our warranty. Our warranty applies only to the light assembly.

Direct fit replacement for OEM assembly

Uses same wiring as original assembly.  No cutting or splicing required.

Meets federal regulations for on-road use

Item Condition: New

Attention California Customers:

WARNING:  This product can expose you to chemicals including Chromium (Hexavalent Compounds), which is known to the State of California to cause cancer, and birth defects or other reproductive harm.  For more information, go to www.P65Warnings.ca.gov.

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser.

step : Changing the Bulb (0:38)

• Twist the socket counterclockwise.
• Pull the bulb out.
• Push a new one in.
• Twist the socket back into place.

step : Removing the Inside Taillight Assembly (1:19)

• Twist out the sockets.
• Remove the three 8mm nuts.
• Pull the light up and off.

step : Replacing the Inside Taillight Assembly (2:07)

• Line up the light and press it down into place
• Replace the three 8mm nuts.
• Twist the sockets into place.