Replaces

2002-06 Toyota Camry Window Regulator Pair - 1AWRK00134

Description
Warranty & Shipping
How-To & Tools
Product Reviews
Q&A
Vehicle Fit

Part Details

  • Regulator Option:   with Motor
  • Quantity:   Pair
  • Operation:   Power

Specifications:

  • Comes as a PAIR
    • Fits both LH (Driver Side) & RH (Passenger Side) FRONT
  • Includes power window motors which are already installed
  • Replaces dealer part numbers: 69801-AA030, 69801-33050, 69802-AA030, 69802-AA032, 85710-33170, 85720-33170, 85710-AA050, 85720-AA050, 69801AA030, 6980133050, 69802AA030, 69802AA032, 8571033170, 85710AA050, 8572033170, 85720AA050
  • 2 Wire Motors
  • Direct replacements
  • Built to strict quality control standards
  • 100% tested prior to leaving the factory
  • Does NOT fit vehicles that have the Pinch Protection

Item Condition: New

WARNING:  This product can expose you to chemicals including Lead and Lead Compounds, which are known to the State of California to cause cancer, and birth defects or other reproductive harm.  For more information, go to www.P65Warnings.ca.gov.

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser.

  1. step : Removing the Door Panel (0:55)
    • Pry off the trim piece inside the door pull with a flat blade screwdriver
    • Pry off the trim piece inside the door handle with a flat blade screwdriver
    • Pry off the trim piece at the front top corner of the door panel with a flat blade screwdriver
    • Remove the Phillips head screw at the front top corner of the door panel
    • Remove the Phillips head screw inside the door pull
    • Remove the Phillips head screw inside the door handle
    • Pry up the window switch panel by hand
    • Disconnect the window switch wiring harnesses
    • Remove the two Phillips screws at the bottom of the door panel
    • Remove the Phillips screw from the door panel bracket
    • Pry out the door panel by hand
    • Pry off the mirror base trim piece by hand
    • Lift the door panel up and off
    • Disconnect the latch cables from the door handle
    • Carefully pull off the water shield
    • Disconnect the speaker lead
    • Remove four 10mm screws from the speaker
    • Pull off the speaker
  2. step : Removing the Window Regulator (4:24)
    • Disconnect the window motor lead
    • Loosen the two 10mm bolts that hold the window to the regulator
    • Raise the window by hand
    • Hold the window in place with painter's tape
    • Remove the four 10mm bolts from the regulator
    • Remove the two 10mm bolts from the window track
    • Pull the window regulator out through the door
  3. step : Separating the Window Motor from the Regulator (6:44)
    • Pull off the balance spring with pliers
    • Remove the three T25 Torx screws from the window motor
    • Pull the motor away from the regulator
  4. step : Resetting the Motor (7:27)
    • Connect the window switch wiring harness
    • Connect the window motor to the lead
    • Turn the vehicle on
    • Run the motor up for 4 seconds
    • Disconnect the window motor lead
  5. step : Reinstalling the Motor (6:25)
    • Pull back the window motor bracket on the regulator
    • Pull the balancing spring into place
    • Pull the bracket back to the middle
    • Put the motor onto the bracket
    • Insert the three T25 bolts into the motor
  6. step : Reinstalling the Regulator (10:01)
    • Insert one of the bolts into the window regulator
    • Push the regulator into the door
    • Hang the regulator by its bolt
    • Insert the four 10mm bolts into the regulator
    • Insert the two 10mm bolts into the window track
    • Remove the painter's tape from the window
    • Lower the window onto the regulator
    • Insert the two 10mm bolts that hold the window to the regulator
    • For more detailed instructions, please see the 2005 Camry window regulator replacement video
  7. step : Resetting the Auto-Pinch Feature (10:50)
    • Connect the window motor lead
    • Run the window up and down three times with the switch
    • Then raise the window with the auto setting
    • Disconnect the window switch wiring harness
  8. step : Reinstalling the Door Panel (11:59)
    • Put the water shield into place
    • Put the speaker into place
    • Insert the four 10mm bolts into the speaker
    • Connect the speaker wiring lead
    • Connect the latch cables to the door handle
    • Lift the door panel into place
    • Push in the door panel
    • Insert the Phillips screw into the door panel bracket
    • Insert the Phillips screw at the top front corner of the door panel
    • Push on the trim piece at the top front corner of the door panel
    • Insert the Phillips screw into the door handle
    • Push on the trim piece inside the door handle
    • Insert the two Phillips screws at the bottom of the door panel
    • Connect the window switch wiring harnesses
    • Push in the window switch panel
    • Insert the Phillips screw into the door pull
    • Push in the door pull trim piece
    • Push on the mirror base trim piece

Tools needed for replacement:

    Pliers, Cutters & misc Wrenches

  • Slip-Joint Pliers

  • Ratchets & Related

  • Ratchet

  • Screwdrivers & Related

  • Flat Blade Screwdriver
  • Phillips Head Screwdriver

  • Sockets - Metric

  • 10mm Socket

5.00/ 5.0
1review
5 Stars
4 Stars
3 Stars
2 Stars
1 Star
1
0
0
0
0
Solid Purchase
With the 1A Auto parts and youtube, my 16 year-old son was able to do the repair...
February 14, 2017
Will this fit my car? Add a vehicle to make sure
Customer Q&A
Ask a question to 1A Auto customers who purchased the product
No questions have been asked about this item.
Year Make Model Description
2002-2006Toyota Camry Toyota Camry without Anti-Pinch Option Front Power Window Regulator with Motor Pair
Part #: 1AWRK00134


Order must be placed by 4pm ET

Get it in: 2 - 4 Business Days

Want it sooner? Choose Next Day Air at Checkout

How-to Video:

(12:56 min)