Part Details

  • Regulator Option: with Motor
  • Operation: Power

This power window regulator with motor is a high quality replacement. The benefit of our regulator is our manufacturer. They studied the faults of the original equipment manufacturer, then made changes and re-engineered to correct those faults.

Specifications:

  • LH (Driver Side) FRONT DOOR
  • Replaces dealer part numbers: 69802-AA030, 69802-AA032, 85720-33170, 85720-AA050, 69802AA030, 69802AA032, 8572033170, 85720AA050
  • Includes power window motor which is already installed
  • 2 Wire Motor
  • Direct replacement
  • Built to strict quality control standards
  • 100% tested prior to leaving the factory
  • Does NOT fit vehicles that have the Pinch Protection

Assembly includes pre-assembled motor & regulator as shown.

Window Regulator Installation Tips and FAQ.

This regulator makes a great replacement and has good cost savings over a dealer unit.

Please Note:

This window regulator is a high quality aftermarket part that meets or exceeds the performance of the original. It has been subjected to extensive testing and quality control standards. That is why we offer this regulator with our superior warranty!

Direct Fit

Direct fit, pre-assembled parts made ready to fit your vehicle and provide easy and trouble-free installation.

Rigorously Tested

Build to strict quality standards

Highest Quality Materials

Made from the highest quality materials for extreme durability and premium performance.

Item Condition: New

WARNING:  This product can expose you to chemicals including Lead and Lead Compounds, which are known to the State of California to cause cancer, and birth defects or other reproductive harm.  For more information, go to www.P65Warnings.ca.gov.

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser.

  1. step : Removing the Door Panel (0:55)
    • Pry off the trim piece inside the door pull with a flat blade screwdriver
    • Pry off the trim piece inside the door handle with a flat blade screwdriver
    • Pry off the trim piece at the front top corner of the door panel with a flat blade screwdriver
    • Remove the Phillips head screw at the front top corner of the door panel
    • Remove the Phillips head screw inside the door pull
    • Remove the Phillips head screw inside the door handle
    • Pry up the window switch panel by hand
    • Disconnect the window switch wiring harnesses
    • Remove the two Phillips screws at the bottom of the door panel
    • Remove the Phillips screw from the door panel bracket
    • Pry out the door panel by hand
    • Pry off the mirror base trim piece by hand
    • Lift the door panel up and off
    • Disconnect the latch cables from the door handle
    • Carefully pull off the water shield
    • Disconnect the speaker lead
    • Remove four 10mm screws from the speaker
    • Pull off the speaker
  2. step : Removing the Window Regulator (4:24)
    • Disconnect the window motor lead
    • Loosen the two 10mm bolts that hold the window to the regulator
    • Raise the window by hand
    • Hold the window in place with painter's tape
    • Remove the four 10mm bolts from the regulator
    • Remove the two 10mm bolts from the window track
    • Pull the window regulator out through the door
  3. step : Separating the Window Motor from the Regulator (6:44)
    • Pull off the balance spring with pliers
    • Remove the three T25 Torx screws from the window motor
    • Pull the motor away from the regulator
  4. step : Resetting the Motor (7:27)
    • Connect the window switch wiring harness
    • Connect the window motor to the lead
    • Turn the vehicle on
    • Run the motor up for 4 seconds
    • Disconnect the window motor lead
  5. step : Reinstalling the Motor (6:25)
    • Pull back the window motor bracket on the regulator
    • Pull the balancing spring into place
    • Pull the bracket back to the middle
    • Put the motor onto the bracket
    • Insert the three T25 bolts into the motor
  6. step : Reinstalling the Regulator (10:01)
    • Insert one of the bolts into the window regulator
    • Push the regulator into the door
    • Hang the regulator by its bolt
    • Insert the four 10mm bolts into the regulator
    • Insert the two 10mm bolts into the window track
    • Remove the painter's tape from the window
    • Lower the window onto the regulator
    • Insert the two 10mm bolts that hold the window to the regulator
    • For more detailed instructions, please see the 2005 Camry window regulator replacement video
  7. step : Resetting the Auto-Pinch Feature (10:50)
    • Connect the window motor lead
    • Run the window up and down three times with the switch
    • Then raise the window with the auto setting
    • Disconnect the window switch wiring harness
  8. step : Reinstalling the Door Panel (11:59)
    • Put the water shield into place
    • Put the speaker into place
    • Insert the four 10mm bolts into the speaker
    • Connect the speaker wiring lead
    • Connect the latch cables to the door handle
    • Lift the door panel into place
    • Push in the door panel
    • Insert the Phillips screw into the door panel bracket
    • Insert the Phillips screw at the top front corner of the door panel
    • Push on the trim piece at the top front corner of the door panel
    • Insert the Phillips screw into the door handle
    • Push on the trim piece inside the door handle
    • Insert the two Phillips screws at the bottom of the door panel
    • Connect the window switch wiring harnesses
    • Push in the window switch panel
    • Insert the Phillips screw into the door pull
    • Push in the door pull trim piece
    • Push on the mirror base trim piece

Tools needed for replacement:

    Pliers, Cutters & misc Wrenches

  • Slip-Joint Pliers

  • Ratchets & Related

  • Ratchet

  • Screwdrivers & Related

  • Flat Blade Screwdriver
  • Phillips Head Screwdriver

  • Sockets - Metric

  • 10mm Socket

5.0 / 5.0
5 Reviews
5 Stars
4 Stars
3 Stars
2 Stars
1 Star
5
0
0
0
0
Perfect Fit, Works Great
This was a lower cost alternative that I found after viewing the installation video at 1A Auto on Utube. I had to check with a Toyota Service Manager to see if my 2002 Camry had a pinch or non-pinch option as the old regulator was not working at all. I ordered the correct part, got it installed (video was great and very helpful), and it works great. The only difference was the connector (pointed out in the video) but it plugs right in and does not get in the way when you put the door panel back in place. Thanks!
September 18, 2018
Purchased
3 weeks ago
Works perfectly- nice video
Very easy to install and instruction video was perfect.
November 20, 2017
Purchased
10 months ago
Toyota Window Regulator
Bought to replace original part that aas 14 plus years old. It took me about 1 and a half hours to install
Appears to be a quality part and it fit with no problems. I wiuld definitely recommend getting the part and installing yourself.
October 6, 2017
Purchased
1 year ago
Works great
Installed easily and matched up just fine against the OEM parts.
September 12, 2017
Purchased
1 year ago
For the price awesome deal. Only thing is it's not OME part so there is things that are a little different than the original the plug in cord is different from the original.
April 22, 2017
Purchased
1 year ago
Start typing your question and we'll check if it was already asked and answered. Learn More
Browse 1 question Browse 1 question and 2 answers
my 2006 camery was made in japan will this motor and regulator fit if not tell me what will? It does not have anti pinch it
kevin h on Jan 2, 2018
BEST ANSWER: Yes, according to the information you supplied, the part you’re looking at will be correct for your vehicle. If you have any other questions or would like to place an order with one of our customer service representatives, please feel free to give us a call.

Vehicle Fit

Year Make Model Description
2002-2006Toyota Camry Toyota Camry without Anti-Pinch Option Front Power Window Regulator with Motor Driver Side

This part replaces:

  • Hollander 125-58911
  • Dorman 741-920
Part #: 1AWRG00562


Order must be placed by 4pm ET

Get it in: 2 - 4 Business Days

Want it sooner? Choose Next Day Air at Checkout

How-to Video:

(12:56 min)