Replaces

2002-06 Nissan Altima Exterior Door Handle Rear Driver Side - 1ADHE00854

Specifications:

  • LH (Driver Side) REAR OUTER
  • Replaces dealer part numbers: 82607-8J009, 826078J009
  • Injected molded plastic with Smooth Black Finish
    • Can be painted by buyer to match or installed as is
  • Direct replacement
  • Built to strict quality control standards

Paint To Match Note:

"Paint to match finish" refers to a smooth, paintable surface. This item will be shipped unpainted but will be ready for paint. Final preparation is suggested for better paint coverage and adhesion. 

This part can also be installed without painting if desired. 

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser. Please keep your invoice for proof of this warranty.

  1. step : Removing the Door Panel (0:43)
    • Pry off the screw cover inside the door pull with a flat blade screwdriver
    • Remove the Phillips head screw in the door pull
    • Pry off the window switch panel with a flat blade screwdriver
    • Disconnect the window switch wiring harness
    • Pry off the screw cover inside the inner door handle with a flat blade screwdriver
    • Remove the Phillips head screw in the inner door handle
    • Remove the Phillips head screw behind the door pull
    • Remove the two cables from the inner door handle
    • Carefully peel off the water shield with a utility knife, being sure not to rip it
    • Remove the door panel bracket
  2. step : Removing the Outer Door Handle (2:27)
    • Disconnect the door lock wiring harness from the door latch
    • Remove the Phillips screw from the door latch
    • Remove the three Phillips screws that hold the door latch to the outer edge of the door
    • Pull the door latch out through the door
    • Remove the two 10mm bolts from the back of the door handle
    • Pry the door handle locating tab out with a flat blade screwdriver
    • Pull the door handle out from the outer side of the door
  3. step : Installing the New Outer Door Handle (3:43)
    • Paint the door handle to the appropriate color
    • Remove the door handle rod from the old door handle
    • Install the door handle rod into the new door handle
    • Push the door handle into place using the locating tab
    • Push the door latch into place
    • Connect the door handle rod to the door latch
    • Insert the Phillips screw into the door latch
    • Insert the three Phillips screws that hold the door latch to the outer edge of the door
    • Connect the door lock wiring harness to the door latch
  4. step : Reinstalling the Door Panel (5:31)
    • Put the water shield back on
    • Put the door panel bracket on
    • Connect the two cables to the inner door handle
    • Hang the door panel on the window sill
    • Push in the door panel clips
    • Pull the window switch harness through its cavity
    • Insert the Phillips screw behind the door pull
    • Insert the Phillips screw into the door handle
    • Push in the screw cover inside the door handle
    • Connect the window switch wiring harness
    • Push the switch panel into the door panel
    • Insert the Phillips screw into the door pull
    • Push in the screw cover in the door pull

Tools needed for replacement:

    General Tools

  • Utility Knife

  • Ratchets & Related

  • Ratchet

  • Screwdrivers & Related

  • Flat Blade Screwdriver
  • Phillips Head Screwdriver

  • Sockets - Metric

  • 10mm Socket

3.0 / 5.0
1 Review
5 Stars
4 Stars
3 Stars
2 Stars
1 Stars
0
0
1
0
0
No paint
No problem ordering and reviving the handle swiftly as usual.
However, visiting the Nissan dealership to get some matching paint turned out to be a no-no. They only sell touch up pens.
Advice was to contact Sherwin, the paint manufacturer and give them the color code. Have looked at their web page, but it doesn't look that straight forward. Just don't have the time to chase this down, which means the daughter is still driving with her broken handle and the new is on the shelf at her dad's house.
Not A1Auto's fault, but maybe a comment on the web page about paint availability.
/Still a happy customer.
June 20, 2017
Purchased
10 months ago
Response from 1A Auto
Thank you for your purchase. If you would like to color match the door handle to your vehicle you should be able to get a spray bomb made from your local auto body supply store. They will need the paint code off of the vehicle's manufacturer sticker which is typically found on the driver's side door jamb. Hope this helps you out.
June 21, 2017
Tony MStaff
Start typing your question and we'll check if it was already asked and answered. Learn More
No questions have been asked about this item. Be the first!

How-to Video:

(06:45 min)

Tools List:

    General Tools

  • Utility Knife

  • Ratchets & Related

  • Ratchet

  • Screwdrivers & Related

  • Flat Blade Screwdriver
  • Phillips Head Screwdriver

  • Sockets - Metric

  • 10mm Socket



This part replaces:

  • OE # 826078J009
  • Partslink NI1520112
  • Dorman 80429
  • DEPO 315-50007-222

Vehicle Fit

  • 2002-2006 Nissan Altima Smooth - Paint to Match Black Exterior Door Handle Rear Driver Side
Part #: 1ADHE00854

Ships Same Day for orders placed by 4 P.M. ET

We're here to help

1A Auto Parts

Customer Feedback

"Thanks for the fast reliable service. Great price, and the headlights were as good as oem or better!!! Keep up the good work..."
- Dwuan M.
Read More