Replaces

2002-05 GMC Envoy Tail Light Circuit Board Pair - 1ALTP00347

This tail light circuit connector board set is just what you need to get your Tail light working again! This circuit board features the following specifications:

  • Includes LH and RH side
  • High quality item that is built to strict quality control standards
  • Direct bolt on ~ Easy to install
  • Replaces burnt and malfunctioning circuit board
  • Allows for just replacement of defective part instead of entire Tail light

This tail light circuit connector board set makes a great replacement and has good cost savings over a dealer circuit board.

 

 

Our electrical and electronic parts are subject to strict quality control testing.  Once the item has been installed or plugged in, it is no longer eligible for a refund.  The item may be eligible for replacement, only if it is found to have a manufacturing defect. Before purchasing, please ensure proper diagnosis of the failed original part is performed

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser. Please keep your invoice for proof of this warranty.

  1. step : Removing the Taillight (0:40)
    • Open the lift gate
    • Remove the two Phillips screws from the taillight bracket
    • Disconnect the headlight wiring harness
  2. step : Removing the Circuit Board and Servicing the Bulbs (1:04)
    • Remove the three Phillips screws from the circuit board
    • Pull the circuit board out
    • Pull the bulb off of the socket
    • Push on the new bulb
    • Push the bulb onto the socket
    • Push the circuit board into the light
    • Insert and tighten the three Phillips screws into the circuit board
  3. step : Installing the New Taillight (2:15)
    • Push in the tabs on the plate on the old taillight and remove it
    • Connect the plate to the new taillight
    • Reconnect the wiring harness to the taillight
    • Line up the bolt holes on the taillight bracket to the bolt holes on the vehicle
    • Replace the two Phillips screws into the taillight bracket

Tools needed for replacement:

    Screwdrivers & Related

  • Phillips Head Screwdriver

There are no reviews for this item. Write Review
Start typing your question and we'll check if it was already asked and answered. Learn More
No questions have been asked about this item. Be the first!

Vehicle Fit

  • 2002-2005 GMC Envoy Tail Light Circuit Board Pair

This part replaces:

  • Dorman 923-011 x2
Only 1 left in stock
Part #: 1ALTP00347

Ships Same Day for orders placed by 4 P.M. ET

How-to Video:

(03:14 min)