This replacement Manifold Absolute Pressure Sensor (MAP) is a new aftermarket part. It is just what you need to get your vehicle in good running condition again!

How this part works is that it measures the intake manifold pressure and relays this information to the vehicles ECM or main computer. The ECM then uses this data to calculate air density and determine the engine's air mass flow rate, which in turn determines the required fuel metering for optimum combustion.

A bad or malfunctioning MAP sensor will often cause a service engine light error code, and or cause a no start condition, or rough running due to inaccurate ignition and fuel timing.

This MAP sensor features:

  • Mounts near the intake manifold
  • Replaces dealer part numbers: 4896131AB, 4896131AC
  • Direct replacement
  • Built to strict quality control standards
  • 100% factory tested
  • 3 Pin Connector



Our electrical and electronic parts are subject to strict quality control testing.  Once the item has been installed or plugged in, it is no longer eligible for a refund.  The item may be eligible for replacement, only if it is found to have a manufacturing defect. Before purchasing, please ensure proper diagnosis of the failed original part is performed


Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser.

  1. step : Removing the Manifold Absolute Pressure (MAP) Sensor (0:34)
    • Disconnect the MAP sensor wiring harness
    • Remove the 7mm bolt from the MAP sensor
    • Pull the MAP sensor up and out of the intake manifold
  2. step : Installing the MAP Sensor (1:10)
    • Push the new MAP sensor into the intake manifold
    • Insert the 7mm bolt into the MAP sensor
    • Connect the MAP sensor wiring harness

Tools needed for replacement:

    Ratchets & Related

  • Ratchet
  • Swivel
  • Socket Extensions

  • Sockets - Metric

  • 7mm Socket

There are no reviews for this item. Write Review
Start typing your question and we'll check if it was already asked and answered. Learn More
No questions have been asked about this item. Be the first!

Vehicle Fit

  • 2002-2004 Chrysler Sebring MAP Sensor V6 2.7L
  • 2002-2004 Dodge Stratus MAP Sensor V6 2.7L

This part replaces:

  • OE # 4896131AC
  • OE # 4896131AB
  • Standard Motor Products AS219
Only 3 left in stock
Part #: 1AEMP00005

How-to Video:

(01:52 min)