2002-04 Honda Odyssey Tail Light - 1ALTL00524

This replacement Honda Odyssey tail light is just what you need to get your Honda in good looking form again!

This tail light features:

• Left Hand (Driver side)
• Replaces dealer Part Number: 33506-S0X-003
• Mounts on 1/4 panel
• Assembly includes lens and housing
• Department of Transportation (DOT) & Society of Automotive Engineers (SAE) approved
• Direct replacement
• Built to strict quality control standards
• Bulbs and wiring not included

This Honda Odyssey tail light makes a great replacement and has good cost savings over a dealer unit.

Bulb Note:

Unless otherwise noted, our lights do not include bulbs, though occasionally lighting manufacturers do include bulbs in the lights. If you happen to receive a lighting product (Headlight, Tail light, parking light, fog light etc.) that comes with the bulbs, the bulbs are not covered under our warranty. Our warranty applies only to the light assembly.

Direct fit replacement for OEM assembly

Uses same wiring as original assembly.  No cutting or splicing required.

Meets federal regulations for on-road use

Item Condition: New

Attention California Customers:

WARNING:  This product can expose you to chemicals including Chromium (Hexavalent Compounds), which is known to the State of California to cause cancer, and birth defects or other reproductive harm.  For more information, go to www.P65Warnings.ca.gov.

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser.

step : Remove the tail light assembly (0:47)

• Open the trunk.
• Use a flat blade screwdriver to pry back the covers in the trunk door jamb to access the bolts anchoring the tail light assembly.
• With your 8 mm socket and ratchet, unbolt the two 8 mm bolts anchoring the tail light assembly.
• Pull the tail light assembly out.
• Unplug the wiring harness.
• Service the bulbs or remove the bulbs to transfer over to the new assembly.

step : Install the new light (3:05)

• Plug in the bulbs and wiring harness.
• Clip the tail light assembly into place.
• Bolt in the tail light assembly with your 8 mm socket and ratchet.
• Click the bolt covers back down and close the trunk.