2002-03 Pontiac Grand Am Mirror Pair - 1AMRP00115

This replacement pair of mirrors is just what you need to get your Van in good looking form again!

Specifications:

• Comes as a Pair
• Power operation
• Spring mounted base
• Non Folding
• Replaces dealer part number 22688826 and 22688827
• Injection molded black plastic housings
• Direct replacement mirrors
• Built to strict quality control standards

These mirrors make great replacements and have substantial cost savings over dealer parts.

Special Note:

• Unless otherwise noted, replacement mirrors will only work properly on vehicles with the exact same options. If your vehicle does not have the options listed in specifications, the mirror(s) may not function properly.

Item Condition: New

Attention California Customers:

WARNING:  This product can expose you to chemicals including Lead and Lead Compounds, which are known to the State of California to cause cancer, and birth defects or other reproductive harm.  For more information, go to www.P65Warnings.ca.gov.

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser.

step : Removing the Door Panel (1:02)

• Remove the triangular trim panel and disconnect the harness.
• Remove the insulation
• Pry up the switch panel and disconnect the harnesses.
• Remove the screw in the door handle bezel.
• Remove the uncovered screws as well as one under the pull handle.
• Remove the reflector and screw behind it.
• Use a putty knife to pry out the door panel clips.
• Disconnect the harnesses from the door panel.

step : Removing the Side Mirror (2:31)

• Disconnect the mirror harness.
• Remove the three 10mm nuts that secure the side mirror.
• Pull the mirror out and off.

step : Replacing the Side Mirror (3:22)

• Feed the harness down into the door
• Replace the three 10mm nuts.
• Reconnect the mirror harness

step : Replacing the Door Panel (5:54)

• Line up the door panel and push it into place.
• Replace the screws.
• Replace the door handle bezel and the screw that secures it.
• Replace the switch panel harnesses and push the switch panel down into place.
• Replace the mirror insulation.
• Reconnect the triangular trim panel harness and push the panel back into place.