This replacement Nissan Maxima XENON HID (high intensity discharge) headlight is just what you need to get your car in good looking form again!

Specifications

  • LH (driver's side)
  • Replaces dealer part numbers: 260605Y725, 26060-5Y725
  • Includes HID bulbs, ballast (transformer), and all associated transformer wiring
  • DOT (Department of Transportation) & SAE (Society of Automotive Engineers) approved
  • Direct replacement
  • Built to strict quality control standards

This Nissan Maxima headlight is a great replacement and has substantial cost savings over a head light from the dealer.

 

Direct Fit Replacement

Direct fit replacement for OEM assembly

Trouble-free Installation

Uses same wiring as original assembly.  No cutting or splicing required.

DOT and SAE Compliant

Meets federal regulations for on-road use

Part Details

  • Light Option: HID (High-Intensity Discharge)

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser.

Bulb Note:

Unless otherwise noted, our lights do not include bulbs, though occasionally lighting manufacturers do include bulbs in the lights. If you happen to receive a lighting product (Headlight, Tail light, parking light, fog light etc.) that comes with the bulbs, the bulbs are not covered under our warranty. Our warranty applies only to the light assembly..

  1. step : Removing the Bumper Cover (0:56)
    • Remove the four clips at the top of the bumper cover by prying up the middle of the clip and pulling the clip out.
    • Remove the Phillips screws under the bumper cover in front of each wheel.
    • Remove the series of clips under the bumper cover.
    • Pull the inner fender back.
    • Remove the upper 10mm bolt behind the inner fender.
    • Carefully pry out the parking lights.
    • Remove the 10mm bolts behind the parking lights.
    • Pull the bumper cover forward and disconnect the fog lights.
    • Pull the bumper cover free.
  2. step : Removing the Headlights (4:47)
    • Use pliers to bend the cover on the lower 14mm bolt under the headlight.
    • Remove the two 14mm bolts under the headlight in the security bracket.
    • Remove the bracket.
    • Remove the two 10mm bolts at the top of the headlight.
    • Pull the headlight forward.
    • Disconnect the harnesses.
    • Pull the headlight assembly up and out.
  3. step : Replacing the Headlight Assembly (7:31)
    • Reconnect the harnesses.
    • Line up the clips on the headlight and push it into place on the car.
    • Replace the two 10mm bolts at the top of the headlight.
    • Reconnect the fog lights on the bumper cover.
    • Put the bumper cover back into place and reinsert the four clips at the top of the bumper cover.
    • Replace the bolts behind the inner fender.
    • Replace the side marker lights.
    • Push the inner fender back into place.
    • Push the bottom panel up and over the front of the bumper cover.
    • Replace the clips under the bumper cover.
    • Reinsert the two Phillips screws under the bumper cover.

Tools needed for replacement:

    Pliers, Cutters & misc Wrenches

  • Needle nose pliers

  • Ratchets & Related

  • Socket Extensions
  • Ratchet

  • Screwdrivers & Related

  • Flat Blade Screwdriver
  • Phillips Head Screwdriver

  • Sockets - Metric

  • 10mm Socket
  • 14mm Socket

There are no reviews for this item. Write Review
Start typing your question and we'll check if it was already asked and answered. Learn More
Browse 1 question Browse 1 question and 1 answer
We need the ballast for 2003 nissian maxima se?
Evelyn J on Apr 12, 2016
BEST ANSWER: We do not carry the ballast separately, but you can order the pair of headlights with the ballast and a lifetime warranty. I added the link below.

http://www.1aauto.com/2002-03-nissan-maxima-headlight-pair/i/1alhp00088?f=269627&y=2003

Vehicle Fit

Year Make Model Description
2002-2003Nissan Maxima Nissan Maxima HID (High-Intensity Discharge) Headlight Driver Side

This part replaces:

  • Partslink NI2502144
  • Hollander 114-58884L
  • TYC 20-6626-00-1
  • DEPO 315-1144L-AF
  • OE # 260605Y725
Part #: 1ALHL00761


Order must be placed by 4pm ET

Get it in: 2 - 4 Business Days

Want it sooner? Choose Next Day Air at Checkout

How-to Video:

(11:41 min)