Replaces

2001-07 Toyota Highlander Windshield Wiper Transmission - 1AWWT00105

Description
Warranty & Shipping
How-To & Tools
Product Reviews
Q&A
Vehicle Fit

Snow, ice, dirt, and dust can interfere or damage your windshield wipers and the motion transmission mechanism. A bent or damaged link can cause the wipers to not work or work incompletely. These parts will also cause an annoying squeaking when they wear out. In general replacing windshield wiper transmission parts is not difficult. This may vary on some applications. It requires basic tools and removal and installation of small body parts such as cowl vent grilles. This replacement wiper transmission arm may be just what you need to get your windshield wiper system working properly again.

Specifications:

  • Complete Windshield Wiper Transmission Assembly
  • Replaces dealer part number: 85150-48060, 8515048060
  • Direct bolt on
  • Built to strict quality control standards

This wiper transmission makes a great replacement and has good cost savings over a dealer unit.

Item Condition: New

Attention California Customers:

WARNING:  This product can expose you to chemicals including Lead and Lead Compounds, which are known to the State of California to cause cancer, and birth defects or other reproductive harm.  For more information, go to www.P65Warnings.ca.gov.

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser.

  1. step : Removing the Wiper Arms (0:47)
    • Mark the position of the wiper blades with painter's tape
    • Pry off the wiper arm caps with a flat blade screwdriver
    • Remove the 14mm nut from each wiper arm stud
    • Pull the wiper arms off the studs
  2. step : Removing the Hood Cowl (2:26)
    • Open the hood
    • Release the push clip from each side of the cowl with a flat blade screwdriver
    • Push in the tabs underneath the hood cowl with a flat blade screwdriver, while lifting the cowl
    • Unclip the cowl from the windshield
  3. step : Removing the Wiper Transmission (4:09)
    • Disconnect the wiper motor
    • Remove the two 10mm bolts from the wiper transmission
    • Slide the wiper motor assembly off of the pin
    • Remove the wiper transmission
  4. step : Removing the Wiper Transmission Motor (6:28)
    • Break the 12mm nut free from the wiper motor with a 12mm wrench
    • Remove the two T30 Torx bolts from the wiper motor
    • Tap the nut on the wiper motor free with a ball peel hammer
    • Remove the old transmission
  5. step : Installing the Wiper Transmission Motor (8:00)
    • Connect the motor to the transmission
    • Tighten the T30 Torx bolts to the motor
    • Place the transmission on the wiper motor
    • Tighten the bolt and lock washer
    • Tighten the 12mm bolt to the wiper motor
  6. step : Installing the Wiper Transmission (10:17)
    • Insert the wiper transmission into place
    • Tighten the two 10mm bolts to the wiper transmission
    • Connect the wiper motor
    • Let the wiper motor run to reset the transmission into the park position
  7. step : Installing the Hood Cowl (12:14)
    • Slide the cowl into place
    • Hook the cowl underneath the windshield
    • Push in the cowl tabs
    • Push the push pin into each side of the cowl
    • Close the hood
  8. step : Installing the Wiper Arms (13:45)
    • Line up the wiper arm marked P with the passenger side stud and painter's tape
    • Make sure the wiper arm is positioned correctly
    • Fasten the 14mm nut onto the wiper arm stud
    • Line up the wiper arm marked D with the driver side stud and painter's tape
    • Make sure the wiper arm is positioned correctly
    • Fasten the 14mm nut onto the wiper arm stud
    • Pop the cap onto each wiper arm
    • Remove the painter's tape from the windshield

Tools needed for replacement:

    General Tools

  • Hammer

  • Ratchets & Related

  • Socket Extensions
  • Ratchet

  • Screwdrivers & Related

  • Flat Blade Screwdriver

  • Sockets - Metric

  • 12mm Socket
  • 14mm Socket

  • Torx Drivers & Sockets

  • T30 Torx Driver

There are no reviews for this item.
Will this fit my car? Add a vehicle to make sure
Customer Q&A
Ask a question to 1A Auto customers who purchased the product
Do you sell just the linkage and bushings?
Jose R February 21, 2017
At this time we only offer the complete assembly as shown.
Alex P February 21, 2017
Year Make Model Description
2001-2007Toyota Highlander Toyota Highlander Windshield Wiper Transmission
Part #: 1AWWT00105


Order must be placed by 4pm ET

Get it in: 2 - 4 Business Days

Want it sooner? Choose Next Day Air at Checkout

How-to Video:

(15:45 min)