Replaces

2001-06 Hyundai Elantra Steering & Suspension Kit - 1ASFK03395

Specifications:

  • Brand New Steering & Suspension Kit
  • Comes as a 8 Piece Kit
    • Fits LH (Driver Side) & RH (Passenger Side)
  • Direct replacement
  • Built to strict quality control standards

Our steering and suspension components come pre-greased, sealed for long life, and do not require the extra maintenance typically required by greasable versions.

Please Note: Whenever replacing steering components, it is highly recommended to have a professional alignment performed on the vehicle afterwards.  Failure to do so may result in issues with steering and premature tire wear.

Direct Fit

All parts are direct fit, application-specific parts with no modifications required

Rigorously Tested

Rigorously tested and made from higher quality materials than the competition. Our parts are built to have a longer life in any environment or road conditions.

State of the Art Manufacturing

Our parts are manufactured by some of the same factories that the OEMs use.

Prepackaged for Your Convenience

Our kits have been carefully put together to include all of the parts you need to get the job done, saving you both time and money. These kits also help take the guesswork out of finding the correct part for your vehicle’s steering or suspension system, allowing you to get started on your repair project faster.

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser. Please keep your invoice for proof of this warranty.

    After completing this repair, it's recommended to have your car aligned

  1. step : Removing the Wheel (0:52)
    • Loosen the lug nuts with the vehicle on the ground
    • Remove the hubcap
    • Raise the vehicle with a floor jack
    • Secure the vehicle on jack stands
    • Remove the lug nuts
    • Pull off the wheel
  2. step : Removing the Outer Tie Rod (1:12)
    • Measure from the end of the tie rod boot to the end of the tie rod
    • Spray the 22mm nut on the outer tie rod with penetrating oil
    • Hold the inner tire rod with a 13mm wrench
    • Loosen the nut on the outer tie rod with a 22mm wrench
    • Remove the cotter pin from the ball joint nut with pliers
    • Remove the 17mm nut from the ball joint
    • Hit the spindle with a hammer to knock the ball joint free
    • Spin the outer tie rod free
  3. step : Installing the New Outer Tie Rod (3:00)
    • Screw the grease fitting on the bottom of the new tie rod
    • Tighten it with a 7mm socket
    • Twist the outer tie rod into the inner tie rod
    • Measure from the outside of the boot to the inside of the tie rod to match your previous measurement
    • Hold the outer tie rod with a wrench while tightening the 22mm nut to the tie rod
    • Attach a grease gun to the ball joint fitting and give it several pumps
  4. step : Reattaching the Wheel (4:42)
    • Slide the wheel into place
    • Replace the hub cap
    • Start the lug nuts by hand
    • Tighten the lug nuts preliminarily
    • Lower the vehicle to the ground
    • Tighten the lug nuts to between 100 foot-pounds in a crossing or star pattern

Tools needed for replacement:

    General Tools

  • Hammer
  • Jack Stands
  • Floor Jack

  • Materials, Fluids, and Supplies

  • Bearing Grease
  • Rust Penetrant

  • Pliers, Cutters & misc Wrenches

  • Adjustable Wrench
  • Needle nose pliers

  • Ratchets & Related

  • Torque Wrench
  • A Piece of Pipe (for leverage)
  • Ratchet

  • Sockets - Metric

  • 22mm Socket
  • 7mm Socket
  • 17mm Socket

  • Specialty Tools

  • Grease Gun

  • Wrenches - Metric

  • 13mm Wrench
  • 22mm Wrench

There are no reviews for this item. Write Review
Start typing your question and we'll check if it was already asked and answered. Learn More
No questions have been asked about this item. Be the first!

Vehicle Fit

  • 2001-2006 Hyundai Elantra 10 Piece Set Steering & Suspension Kit

This part replaces:

  • Beck Arnley 103-2879
  • Moog K500031
  • OE # 5483034500
  • OE # 56820-22000
  • OE # 577242F000, 577242D000
  • OE # 5453031600
  • Moog K90358
  • Moog ES3377
  • Moog EV80310
Part #: 1ASFK03395

Out of Stock

How-to Video:

(05:41 min)