Replaces

2001-06 Hyundai Elantra Heater Blower Motor with Fan Cage - 1AHCX00196

This Hyundai Elantra heater blower motor with fan cage is a new, aftermarket replacement part. It is just what you need to bring your heating and A/C blower system back to good working order! This assembly has the following

Specifications:

  • New, not remanufactured or rebuilt
  • Includes blower motor fan cage impeller already installed
  • Direct replacement
  • Replaces dealer part numbers: 97113-2D010, 971132D010, 97113-2D000, 971132D000
  • Built to strict quality control standards
  • 100% tested prior to leaving the factory

If you are experiencing intermittent stopping during use, squealing noise from bearings, or poor air flow from your dash vents this may be your solution.

Our electrical and electronic parts are subject to strict quality control testing.  Once the item has been installed or plugged in, it is no longer eligible for a refund.  The item may be eligible for replacement, only if it is found to have a manufacturing defect. Before purchasing, please ensure proper diagnosis of the failed original part is performed

Left Hand Drive Note:

“All of our auto parts are intended for Left Hand Drive USDM vehicles and might not have been tested on Right Hand Drive platforms. If your vehicle is Right Hand Drive, please do your research prior to making a purchase to ensure the part is correct for your specific vehicle.”

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser. Please keep your invoice for proof of this warranty.

  1. step : Removing the Blower Motor (0:41)
    • Disconnect the blower motor wiring harness
    • Pull off the drain pipe
    • Remove the three Phillips head screws from the blower motor
    • Remove the Phillips screw from the wiring harness bracket
    • Pull out the blower motor
  2. step : Installing the New Blower Motor (1:31)
    • Push the new blower motor into place with the wiring connector facing the cabin
    • Insert the three Phillips screws into the blower motor
    • Insert the Phillips screw into the wiring harness bracket
    • Connect the wiring harness to the blower motor
    • Connect the drain pipe

Tools needed for replacement:

    Screwdrivers & Related

  • Phillips Head Screwdriver

There are no reviews for this item. Write Review
Start typing your question and we'll check if it was already asked and answered. Learn More
No questions have been asked about this item. Be the first!

Vehicle Fit

  • 2001-2006 Hyundai Elantra Heater Blower Motor with Fan Cage

This part replaces:

  • OE # 971132D010
  • Hollander 615-58538
  • TYC 700117
Part #: 1AHCX00196

Ships Same Day for orders placed by 4 P.M. ET

How-to Video:

(03:05 min)