Replaces

2001-05 Honda Civic Exterior Door Handle - 1ADHE00771

This replacement exterior door handle is just what you need to get your vehicle in good looking form again!

Specifications:

  • Fits RH (Passenger Side) FRONT DOOR
  • Smooth Black Finish
    • can be painted by buyer to match or installed as is
  • Replaces dealer part numbers: 72140-S5A-013, 72140-S5D-A02, 72140S5A013, 72140S5DA02
  • Durable construction
  • Direct replacement
  • Built to strict quality control standards

This exterior door handle is a great replacement and has good cost savings over a dealer unit.

Paint To Match Note:

"Paint to match finish" refers to a smooth, paintable surface. This item will be shipped unpainted but will be ready for paint. Final preparation is suggested for better paint coverage and adhesion. 

This part can also be installed without painting if desired. 

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser. Please keep your invoice for proof of this warranty.

  1. step : Removing the Door Panel (0:42)
    • Loosen the negative battery terminal with a 10mm wrench
    • Pry up the trap door in the door pull with a flat blade screwdriver
    • Remove the Phillips screw in the door pull
    • Pry off the trap door in the door handle with a flat blade screwdriver
    • Remove the two Phillips screws in the door handle
    • Pry up the power window switch
    • Disconnect the switch wiring harnesses
    • Pull the door handle out and remove the door handle rod
    • Disconnect the door handle wiring harness
    • Remove the two Phillips screws previously behind the door pull
    • Remove the sail panel
    • Pry out the door panel with a door panel clip tool or putty knife
    • Lift the door panel up and off
    • Remove the pins from the water shield with needle nose pliers
    • Carefully remove the water shield
  2. step : Removing the Door Handle (3:17)
    • Remove the two 10mm bolts from the window
    • Lift the window up and out
    • Remove the 10mm bolt from the bottom of the window track
    • Move the window track out of the way
    • Unlatch the latch rod clip
    • Remove the two 10mm nuts from the door handle
    • Push down on the retaining clip with a flat blade screwdriver
    • Pull the retaining clip down with a bent tip pick tool to loosen the lock cylinder
    • Pry out the door lock cylinder with a flat blade screwdriver
    • Remove the plate
    • Remove the door handle
  3. step : Installing the Door Handle (7:23)
    • Insert the door handle into place
    • Insert the plate into place
    • Hand tighten the 10mm nuts
    • Insert the door lock cylinder into the door handle
    • Reclip the latch rod
    • Tighten the two 10mm nuts
    • Insert the window track into place
    • Tighten the 10mm bolt to the window track
    • Insert the window
    • Tighten the two 10mm bolts to the window
  4. step : Installing the Door Panel (10:07)
    • Replace the water shield and its clips
    • Lift the door panel into place
    • Push in the door panel clips
    • Insert the sail panel into place
    • Insert the two Phillips screws into the door
    • Connect the wiring harness to the power window switch
    • Press the window switch into place
    • Connect the door lock switch to the door handle
    • Connect the door rod into the handle
    • Press the handle into place
    • Tighten the two Phillips screws to the door handle
    • Insert the trim panel into the door handle
    • Tighten the Phillips screw in the door pull
    • Press the trap door into the door pull

Tools needed for replacement:

    General Tools

  • Pick

  • Pliers, Cutters & misc Wrenches

  • Needle nose pliers

  • Ratchets & Related

  • Ratchet
  • Socket Extensions

  • Screwdrivers & Related

  • Phillips Head Screwdriver
  • Flat Blade Screwdriver

  • Sockets - Metric

  • 10mm Socket

  • Wrenches - Metric

  • 10mm Wrench

4.0 / 5.0
1 Review
5 Stars
4 Stars
3 Stars
2 Stars
1 Stars
0
1
0
0
0
Like new!
Replaced handle and lock after the other handle's plastic broke. Install went smoothly and working like a charm. Cold here and every morning I wonder if it's going to snap off opening the frozen door, but it's holding up well!
February 8, 2018
Purchased
3 weeks ago
Start typing your question and we'll check if it was already asked and answered. Learn More
Browse 1 question Browse 1 question and 1 answer
Do you have an installation video for this?
Warren C on Dec 31, 2015
BEST ANSWER: Hello, Currently no video fr the installation of this part.

How-to Video:

(14:06 min)

Tools List:

    General Tools

  • Pick

  • Pliers, Cutters & misc Wrenches

  • Needle nose pliers

  • Ratchets & Related

  • Ratchet
  • Socket Extensions

  • Screwdrivers & Related

  • Phillips Head Screwdriver
  • Flat Blade Screwdriver

  • Sockets - Metric

  • 10mm Socket

  • Wrenches - Metric

  • 10mm Wrench



This part replaces:

  • OE # 72140S5DA02
  • OE # 72140S5A013

Vehicle Fit

  • 2001-2005 Honda Civic Front Smooth - Paint to Match Black Exterior Door Handle Passenger Side
Part #: 1ADHE00771

Ships Same Day for orders placed by 4 P.M. ET

We're here to help

1A Auto Parts

Customer Feedback

"Thanks for the fast reliable service. Great price, and the headlights were as good as oem or better!!! Keep up the good work..."
- Dwuan M.
Read More