Replaces
2001-05 Buick LeSabre Tail Light - 1ALTL00474
1ALTL00474
This replacement Buick Lesabre tail light is just what you need to get your Buick Le Sabre in good looking form again!
This Buick Lesabre tail light features the following specifications:
- LH (Driver's Side)
- Replaces dealer Part Numbers: 15228559
- Mounts on 1/4 panel
- Assembly includes lens and housing
- Department of Transportation (DOT) & Society of Automotive Engineers (SAE) approved
- Direct replacement
- Built to strict quality control standards
- Bulbs and wiring not included
This Buick Lesabre tail light makes a great replacement and has substantial cost savings over a dealer unit.
Direct Fit Replacement
Direct fit replacement for OEM assembly
Trouble-free InstallationUses same wiring as original assembly. No cutting or splicing required.
DOT and SAE CompliantMeets federal regulations for on-road use
Item Condition:
New
California Customers:
WARNING: This product can expose you to chemicals including Chromium (Hexavalent Compounds), which is known to the State of California to cause cancer, and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov.
Lifetime Warranty
This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser.
Bulb Note:
Unless otherwise noted, our lights do not include bulbs, though occasionally lighting manufacturers do include bulbs in the lights. If you happen to receive a lighting product (Headlight, Tail light, parking light, fog light etc.) that comes with the bulbs, the bulbs are not covered under our warranty. Our warranty applies only to the light assembly.
-
step : Removing the Taillight (0:24)
- Remove the thumb screws.
- Pull off the trim.
- Remove the three 10mm nuts.
- Pull the taillight straight out.
- Twist and pull out each socket.
-
step : Replacing the Bulbs (1:52)
- Pull the bulb out.
- Push a new bulb in.
-
step : Replacing the Taillight (2:01)
- Twist each socket into place.
- Line up the taillight and push it into place.
- Replace the three 10mm nuts.
- Replace the trim.
- Replace the thumb screws.
Tools needed for replacement:
- Ratchet
- 10mm Socket
Ratchets & Related
Sockets - Metric
Vehicle Fit
| Year | Make | Model | Description |
|---|---|---|---|
| 2001-2005 | Buick | LeSabre | Buick LeSabre Tail Light Driver Side |
This part replaces:
- Partslink GM2800151
- Hollander 166-01955L
- TYC 11-5974-91
- DEPO 336-1908L-UF
- OE # 15228559
