This replacement Toyota Sequoia tail light is just what you need to get your Toyota in good looking form again!

This tail light features:

  • Right Hand (Passenger side)
  • Replaces dealer Part Number: 81550-0C020
  • Mounts on 1/4 panel
  • Assembly includes lens and housing
  • Department of Transportation (DOT) & Society of Automotive Engineers (SAE) approved
  • Direct replacement
  • Built to strict quality control standards
  • Bulbs and wiring not included

This Toyota Sequoia tail light makes a great replacement and has good cost savings over a dealer unit.

 

 

Direct Fit Replacement

Direct fit replacement for OEM assembly

Trouble-free Installation

Light uses same wiring as the original assembly, providing easy, trouble-free installation.  No cutting or splicing required.

DOT and SAE Compliant

DOT & SAE compliant: meets federal regulations for on-road use

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser. Please keep your invoice for proof of this warranty.

Bulb Note:

Unless otherwise noted, our lights do not include bulbs, though occasionally lighting manufacturers do include bulbs in the lights. If you happen to receive a lighting product (Headlight, Tail light, parking light, fog light etc.) that comes with the bulbs, the bulbs are not covered under our warranty. Our warranty applies only to the light assembly.

  1. step : Changing a Bulb (0:47)
    • Remove the two 10mm bolts on the taillight.
    • Pull the taillight out and off.
    • Twist the socket out.
    • Pull the bulb straight out.
    • Push a new bulb into place.
    • Twist the socket back into place.
  2. step : Removing the Taillight Assembly (1:57)
    • Switch out the sockets into the new assembly. Or use the following directions on how to remove the harness.
    • Remove the six screws in the sill plate.
    • Remove the 10mm bolt on the inside panel.
    • Pull the plugs out of the inside panel.
    • Pull out on the panel.
    • Disconnect the harness.
    • Pull the taillight out and off.
  3. step : Replacing the Taillight Assembly (3:35)
    • Feed the harness into the vehicle.
    • Line up the taillight and press it into place.
    • Connect the harness.
    • Replace the 10mm bolt and two plugs.
    • Replace the sill panel and the six bolts.
    • Replace the two 10mm bolts in the taillight.

Tools needed for replacement:

    Ratchets & Related

  • Ratchet
  • Socket Extensions

  • Screwdrivers & Related

  • Phillips Head Screwdriver

  • Sockets - Metric

  • 10mm Socket

There are no reviews for this item. Write Review
Start typing your question and we'll check if it was already asked and answered. Learn More
No questions have been asked about this item. Be the first!

Vehicle Fit

  • 2001-2004 Toyota Sequoia Tail Light Passenger Side

This part replaces:

  • Partslink TO2801149
  • Hollander 166-59248R
  • OE # 815500C020
  • TYC 11-6103-00
Only 1 left in stock
Part #: 1ALTL00576



How-to Video:

(05:53 min)