Specifications

  • LH (Driver Side)
  • Includes lens, housing, and mounting panel
  • Replaces dealer part numbers: 81150-02100, 8115002100
  • Bulbs not included

Fit guaranteed

  • This headlamp will install just as your original does. You can use your existing hardware and wiring harnesses.
  • Save time and money with a direct fit. No trips to the hardware store or extra time trying to get the wiring to hookup.

Quality

  • 1A Auto has the most comprehensive warranty.
  • If this headlight should fail to provide satisfactory performance you may exchange it.
  • 1A Auto Headlights are guaranteed to pass inspections in all 50 states. DOT (U.S. Dept. of Transportation) and SAE (Society of Automotive Engineers) approved.

Value

  • Replacing a discolored, scratched, dull or damaged headlight with a headlight from 1A Auto can increase your resale value by up to 10%.

Safety

  • A new headlight can provide you with up to 50% more illumination than a dull, yellowed, sandblasted, broken or scratched headlight.
    • 1A Auto headlights can help you see farther at night and in poor driving conditions.
    • A new headlight from 1A Auto can make you more visible to other traffic during heavy rain or wintry weather..
Direct Fit Replacement

Direct fit replacement for OEM assembly

Trouble-free Installation

Uses same wiring as original assembly.  No cutting or splicing required.

DOT and SAE Compliant

Meets federal regulations for on-road use

Item Condition: New

California Customers:

WARNING:  This product can expose you to chemicals including Chromium (Hexavalent Compounds), which is known to the State of California to cause cancer, and birth defects or other reproductive harm.  For more information, go to www.P65Warnings.ca.gov.

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser.

Bulb Note:

Unless otherwise noted, our lights do not include bulbs, though occasionally lighting manufacturers do include bulbs in the lights. If you happen to receive a lighting product (Headlight, Tail light, parking light, fog light etc.) that comes with the bulbs, the bulbs are not covered under our warranty. Our warranty applies only to the light assembly..

    DO NOT TOUCH the bulbs- the oil from your fingers will burn into the light and foul your bulb. Clean with rubbing alcohol and a soft cloth if the bulbs do get touched.

  1. step : Replacing the Bulb (1:38)
    • Remove two 10 mm bolts securing the fuse box to move it out of the way.
    • Reach into the engine bay behind the headlight assembly and unplug the harness.
    • Unfasten the retaining clip to unplug the bulb.
    • Plug in the new bulb and twist and push it back in.
    • Remove the battery to do the same on the other side.
  2. step : Remove the headlight assembly (3:48)
    • Remove the six 10 mm bolts securing the bumper cover.
    • Use a flat blade screwdriver to remove the push clip on the bumper cover in the center.
    • Remove the push clips in the grill area.
    • Set the bumper cover aside.
    • Use a Phillips screwdriver to remove the screw securing the parking light.
    • Pry off the parking light.
    • Remove the bulb and set aside.
    • Remove the nut and bolt now exposed and the other two on the top and opposing side of the headlight assembly.
    • Unplug the harness from the headlight assembly and set aside.
  3. step : Install headlight assembly (7:30)
    • Preliminarily adjust the new headlight assembly by adjusting the adjustor bolt to the same length as the old assembly.
    • Plug the harness into the new headlight assembly
    • Clip the headlight into place.
    • Use your 10mm socket and ratchet and bolt the assembly back in.
    • Use your Phillips screwdriver to re-install the parking light assembly.
    • Clip the bumper cover back on and use your 10 mm socket and ratchet to bolt the bolt by the far headlight back into place.
  4. step : Install headlight assembly (7:30)
    • Preliminarily adjust the new headlight assembly by adjusting the adjustor bolt to the same length as the old assembly.
    • Plug the harness into the new headlight assembly
    • Clip the headlight into place.
    • Use your 10mm socket and ratchet and bolt the assembly back in.
    • Use your Phillips screwdriver to re-install the parking light assembly.
    • Clip the bumper cover back on and use your 10 mm socket and ratchet to bolt the bolt by the far headlight back into place.

Tools needed for replacement:

    Ratchets & Related

  • Ratchet

  • Screwdrivers & Related

  • Flat Blade Screwdriver
  • Phillips Head Screwdriver

  • Sockets - Metric

  • 10mm Socket

There are no reviews for this item. Write Review
Start typing your question and we'll check if it was already asked and answered. Learn More
No questions have been asked about this item. Be the first!

Vehicle Fit

Year Make Model Description
2001-2002Toyota Corolla Toyota Corolla Headlight Driver Side

This part replaces:

  • Partslink TO2502133
  • Hollander 114-58819L
  • TYC 20-5962-00-1
  • DEPO 312-1148L-AF
  • OE # 8115002100
Part #: 1ALHL00668


Order must be placed by 4pm ET

Get it in: 2 - 4 Business Days

Want it sooner? Choose Next Day Air at Checkout

How-to Video:

(12:33 min)