2001-02 Ford Escape Mirror Pair - 1AMRP00685

Specifications:

• Comes as a Pair
  • Fits both LH (Driver Side) & RH (Passenger Side)
• Power operation
• Manual folding
• Injection molded textured black plastic housing
• Direct replacement mirrors
• Built to strict quality control standards
• Non-heated

Note for 2001-02 Model Ford Escape: This style mirror head is the 1st Design for 2001-02 models. These mirrors will fit 2001-02 Ford Escape models with the 2nd Design mirror heads and 2003-07 Ford Escape XLS/XLT models without modification, but will look different than the original factory design.

Item Condition: New

Attention California Customers:

WARNING:  This product can expose you to chemicals including Lead and Lead Compounds, which are known to the State of California to cause cancer, and birth defects or other reproductive harm.  For more information, go to www.P65Warnings.ca.gov.

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser.

step : Removing the Door Panel (0:49)

• Open the trap door behind the door handle.
• Pry off the circular cap on the inside of the door panel.
• Remove the four Phillips screws around the door panel.
• Pull the door handle bezel out and off.
• Pry out from the corner and release the clips around the door panel.
• Pull the door panel off.
• Disconnect the harness from the door.
• Pry the triangular trim panel out.

step : Removing the Side Mirror (2:21)

• Pull down the water shield and disconnect the connector for the mirror.
• Remove the three 7mm bolts that secure the side mirror.
• Pull the mirror up and out.

step : Replacing the Side Mirror (3:26)

• Feed the harness down through the door.
• Replace the three 7mm bolts.
• Reconnect the mirror harness.

step : Replacing the Door Panel (4:25)

• Replace the triangular trim panel.
• Reconnect the door panel wire harness.
• Put the door panel down into the weather strip and line the door panel pins up.
• Push the door panel into place.
• Replace the door handle bezel.
• Replace the four Phillips screws.
• Replace the trap door and circular cap.