TOYOTA Heater/Air Conditioning Control Knob: 55905-0C010
This knob is a TOYOTA original equipment part! It is the same part that you would receive if you purchased it from your local Toyota dealer!
Specifications:
- (1) - Brand New Toyota HVAC Control Knob
- Fits either Mode, Temperature, or Fan Speed Control
- Black Finish
- Direct replacement
OEM PartGenuine original equipment part (OEM) that was factory installed on your vehicle by the manufacturer.
Item Condition:
New
Lifetime Warranty
This item is backed by our limited lifetime warranty. In the event this item should fail due to manufacturing defects during intended use, we will replace the part free of charge.
-
step : Removing the Heater Control (0:30)
- Pull out the heater selector knob, fan speed knob, and indicator knobs by hand
- Remove the three Phillips screws from each control
- Remove the two Phillips screws from the top of the heater control
- Pry out the trim with a trim tool
- Pull the trim back and off
- Pull the heater control module down and toward you
-
step : Installing the Heater Control (2:20)
- Line up the guides and slide the heater control module up
- Press the trim on
- Tighten the two Phillips screws to the top of the heater control
- Tighten the Phillips screws to each control
- Press on the heater selector knob, fan speed knob, and indicator knobs by hand
Customer Q&A
Ask a question to 1A Auto customers who purchased the product
How do you install the fan knob ?
Johnm W
June 20, 2016
To install the fan knob, rotate the notch in the knob until the flat spot aligns with the flat spot on the shaft coming out of the dash. Simply press fit into place once properly aligned.
Robert B
June 20, 2016
Be sure that the retaining clip from the previous knob is not present on the control stem. If it is then remove it by grasping with a pair of needle-nosed pliers. Align the new knobs flat cutout on the flat of the stem and push firmliy until seated.
Rick P
June 20, 2016
