Replaces

2000-06 Nissan Sentra Window Regulator Passenger Side Front - 1AWRG00347

This replacement power window regulator is just what you need to get your vehicle in good shape again!

Specifications:

  • RH (Passenger Side) FRONT DOOR
  • Power operation
  • Replaces dealer part numbers: 80720-4M400, 807204M400
  • Does NOT include the power window motor
  • Direct replacement
  • Built to strict quality control standards

This power window regulator makes a great replacement and has good cost savings over a dealer unit.

Please Note:  This window regulator is designed to work with factory style motors only.  Due to variations in aftermarket designs, replacement motors may not have the correct gear style.

Please Note: This window regulator is a high quality aftermarket part that meets or exceeds the performance of the original.  It has been subjected to extensive testing and quality control standards.  That is why we offer this regulator with our superior warranty!

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser. Please keep your invoice for proof of this warranty.

  1. step : Removing the Door Panel (0:49)
    • Pry off the door pull panel by hand
    • Pry off the window switch panel by hand
    • Disconnect the window switch wiring harness
    • Remove the 10mm Phillips head bolts behind the door pull
    • Pry off the clip at the front of the door panel
    • Remove the Phillips screw at the bottom of the door panel
    • Pry the door handle bezel off with a flat blade screwdriver
    • Pull the door panel off by hand
    • Carefully remove the water shield with a putty knife
  2. step : Removing the Window Regulator (3:48)
    • Move the window by hand until you can access the window bolts
    • Remove the 10mm window bolts
    • Lift the window by hand
    • Turn the window and pull it out
    • Disconnect the window motor wiring harness
    • Remove the three 10mm bolts from the window motor
    • Remove the four 10mm bolts from the window regulator rail
    • Pull the window regulator and motor out of the door
  3. step : Disconnecting the Window Motor (6:06)
    • Remove the three screws from the window motor with a Phillips head ratchet bit
    • Remove the motor from the regulator
  4. step : Connecting the New Motor to the Regulator (6:59)
    • Line up the motor with the regulator
    • Start the three screws by hand
    • Use the Phillips head ratchet bit to tighten the three screws
  5. step : Reinstalling the Regulator (7:37)
    • Start the top left regulator rail bolt by hand
    • Slide the regulator and motor into the door
    • Hang the regulator in place by the bolt
    • Hang the motor in place with its two teeth
    • Thread all the 10mm bolts by hand
    • Tighten all the bolts with the 10mm socket
    • Connect the window motor wiring harness
    • Slide your window into the door, starting with the front corner
    • Push the window on to its track
    • Insert the bolts that connect the window to the regulator
    • Connect the window switch wiring harness
    • Test that the window works
    • Disconnect the window switch wiring harness
  6. step : Reinstalling the Door Panel (10:06)
    • Carefully put the water shield back on
    • Thread the window switch wiring harness through its cavity
    • Put the door panel on
    • Push the door panel clips in
    • Insert the 10mm Phillips bolts behind the door pull
    • Insert the plastic clip at the front of the door panel
    • Insert the Phillips head screw at the bottom of the door panel
    • Push on the door handle bezel by hand
    • Connect the power window switch wiring harness
    • Push the power window switch into the door starting at the front
    • Push the door pull panel into place

Tools needed for replacement:

    General Tools

  • Putty Knife

  • Ratchets & Related

  • Ratchet
  • Socket Extensions
  • 3/8 Inch Drive Ratchet

  • Screwdrivers & Related

  • Flat Blade Screwdriver
  • Phillips Head Screwdriver

  • Sockets - Metric

  • 10mm Socket

  • Wrenches - Metric

  • 10mm Wrench

There are no reviews for this item. Write Review
Start typing your question and we'll check if it was already asked and answered. Learn More
No questions have been asked about this item. Be the first!

How-to Video:

(12:58 min)

Tools List:

    General Tools

  • Putty Knife

  • Ratchets & Related

  • Ratchet
  • Socket Extensions
  • 3/8 Inch Drive Ratchet

  • Screwdrivers & Related

  • Flat Blade Screwdriver
  • Phillips Head Screwdriver

  • Sockets - Metric

  • 10mm Socket

  • Wrenches - Metric

  • 10mm Wrench



This part replaces:

  • Hollander 125-58833R
  • OE # 807204M400
  • Dorman 740-905

Vehicle Fit

  • 2000-2006 Nissan Sentra Power Window Regulator without Motor Front Passenger Side (High Quality)
Part #: 1AWRG00347

Ships Same Day for orders placed by 4 P.M. ET

We're here to help

1A Auto Parts

Customer Feedback

"Thanks for the fast reliable service. Great price, and the headlights were as good as oem or better!!! Keep up the good work..."
- Dwuan M.
Read More