Replaces

2000-06 Nissan Sentra Window Regulator Pair - 1AWRK00552

These replacement window regulators are just what you need to get your vehicle in good shape again!

Specifications:

  • Comes as a PAIR
    • Fits both the LH (Driver Side) & RH (Passenger Side) REAR DOORS
  • Power operation
  • Includes the power window motors
    • Motors have square connectors
  • Direct replacements
  • Built to strict quality control standards
  • Do NOT fit Mexican Built Models

These window regulators make good replacements and have good cost savings over the dealer units.

Please Note: These window regulators are high quality aftermarket parts that meets or exceeds the performance of the original. They have been subjected to extensive testing and quality control standards. That is why we offer these regulators with our superior warranty!

Installation

  • This repair is easier than you may think. You'll find our installation videos helpful. In our experience removing and replacing the door panel is the most involved step in the repair. On most vehicles this only requires removing a few screws and push-in clips.
  • You'll get a great feeling of accomplishment after you complete this repair knowing you saved money, and you didn't have to give up your car for a day at the repair shop. Your passengers and other drivers will be amazed.

Fit guaranteed

  • 1A Auto will refund you with no hassle if this window regulator does not fit the application stated.
  • This regulator will install just as your original does. Save time and money.

Quality

  • Be confident this part will work right. Every regulator is tested after assembly to make sure all mechanisms are working correctly.
  • It is important that your new regulator works for a long period of time. The design of this regulator is tested to withstand 10,000 cycles. That is enough to raise and lower your window 3 times per day for 9 years.

Value

  • Windows that don't work can be frustrating. They can also hurt your vehicles value. An inoperable window could mean $200-$500 discounted off a dealer trade value or asking price.
  • Some shops and dealers charge more for parts and repairs when they think you don't know what is involved. Now you can get the value you deserve. Knowing what this repair entails can be the difference between the value of doing it yourself, or the pain of a costly repair bill.

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser. Please keep your invoice for proof of this warranty.

  1. step : Removing the Door Panel (0:47)
    • Remove the clip on the side of the panel by turning lightly with a Phillips head
    • Pry up the window switch panel by hand
    • Disconnect the window switch wiring harness
    • Remove the door handle bezel with a flat blade screwdriver
    • Remove the Phillips screws from the door pull with a 10mm socket
    • Pull the door panel off
    • Lift the door panel up and off
    • Carefully peel off the water shield with a putty knife
  2. step : Removing the Window Regulator (3:50)
    • Remove the two 10mm bolts from the regulator brace
    • Disconnect the window motor lead
    • Remove the four 10mm bolts from the regulator
    • Loosen the two 10mm bolts that hold the window to the regulator
    • Raise the window by hand
    • Pull the window regulator out through the door
    • Lower the window by hand
  3. step : Separating the Window Motor from the Regulator (6:30)
    • Remove the two T20 Torx screws from the window motor
    • Pull the motor away from the regulator
  4. step : Reinstalling the Motor (8:00)
    • Put the motor onto the bracket
    • Insert the two T20 bolts into the motor
    • Connect the window switch wiring harness
    • Connect the window motor to the lead
    • Turn the vehicle on
    • Run the motor up for 4 seconds
    • Disconnect the window motor lead
  5. step : Reinstalling the Regulator (9:20)
    • Raise the window
    • Insert one of the bolts into the window regulator
    • Push the regulator into the door
    • Hang the regulator by its bolt
    • Insert the four 10mm bolts into the regulator
    • Lower the window onto the regulator
    • Insert the two 10mm bolts into the window track
    • Connect the window motor lead
    • Remove the two 10mm bolts from the regulator brace
  6. step : Reinstalling the Door Panel (12:09)
    • Put the water shield into place
    • Lift the door panel into place
    • Push in the door panel clips
    • Insert the Phillips screws to the door pull
    • Connect the window switch wiring harness
    • Connect the window switch panel
    • Connect the door handle bezel
    • Re-clip the clip on the side of the panel

Tools needed for replacement:

    General Tools

  • Putty Knife

  • Ratchets & Related

  • Socket Extensions
  • Ratchet

  • Screwdrivers & Related

  • Phillips Head Screwdriver
  • Flat Blade Screwdriver

  • Sockets - Metric

  • 10mm Socket

  • Torx Drivers & Sockets

  • T20 Torx Driver

  • Wrenches - Metric

  • 10mm Wrench

5.0 / 5.0
1 Review
5 Stars
4 Stars
3 Stars
2 Stars
1 Stars
1
0
0
0
0
Wrong item was corrected easily
I ordered these for my Nissan Sentra and after I received them we realized they were the wrong ones.
1 A Auto took care of sending us the correct ones and helping me to return these and gave me my refund in a timely manner. Great customer service. I will definitely order from 1 A Auto again and refer my friends.
March 27, 2018
Purchased
2 months ago
Start typing your question and we'll check if it was already asked and answered. Learn More
No questions have been asked about this item. Be the first!

Vehicle Fit

  • 2000-2006 Nissan Sentra (excluding Mexico Built Models) Rear Power Window Regulator with Motor Pair

This part replaces:

  • OE # 827014Z310, 827215M000, 827315M000, 827305M500, 827305M000
  • Dorman 741-544
  • Dorman 741-545
Part #: 1AWRK00552


How-to Video:

(14:44 min)